davinci: omapl138_lcdk: switch to using TI_COMMON_CMD_OPTIONS

Now that we support using TI_COMMON_CMD_OPTIONS,
we dont have to enable a number of commands explicitly
in the defconfig if we enable TI_COMMON_CMD_OPTIONS.

Enable TI_COMMON_CMD_OPTIONS and regenerate the defconfig
using "make savedefconfig".

CMD_GPIO has been kept disabled because there is no GPIO
support (yet) on OMAP-L138 LCDK.

Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

diff --git a/configs/omapl138_lcdk_defconfig b/configs/omapl138_lcdk_defconfig
index 7a5a78f..752ff5d 100644 (file)
--- a/configs/omapl138_lcdk_defconfig
+++ b/configs/omapl138_lcdk_defconfig
@@ -1,6 +1,7 @@
 CONFIG_ARM=y
 CONFIG_ARCH_DAVINCI=y
 CONFIG_TARGET_OMAPL138_LCDK=y
+CONFIG_TI_COMMON_CMD_OPTIONS=y
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_SPL_MMC_SUPPORT=y
@@ -15,19 +16,10 @@ CONFIG_SPL=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xb5
 CONFIG_HUSH_PARSER=y
 CONFIG_SYS_PROMPT="U-Boot > "
-CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMLS is not set
-CONFIG_CMD_ASKENV=y
 # CONFIG_CMD_FLASH is not set
-CONFIG_CMD_MMC=y
-CONFIG_CMD_PART=y
+# CONFIG_CMD_GPIO is not set
 # CONFIG_CMD_SETEXPR is not set
-CONFIG_CMD_DHCP=y
-CONFIG_CMD_MII=y
-CONFIG_CMD_PING=y
-CONFIG_CMD_EXT2=y
-CONFIG_CMD_FAT=y
-CONFIG_CMD_FS_GENERIC=y
 CONFIG_CMD_DIAG=y
 CONFIG_CMD_UBI=y
 CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y