+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* (C) Copyright 2013
* Heiko Schocher, DENX Software Engineering, hs@denx.de.
* Based on:
* Copyright (c) 2011 IDS GmbH, Germany
* Sergej Stepanov <ste@ids.de>
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __CONFIG_H
/*
* High Level Configuration Options
*/
-#define CONFIG_MPC831x
-#define CONFIG_MPC8313
-#define CONFIG_IDS8313
-
#define CONFIG_FSL_ELBC
-#define CONFIG_MISC_INIT_R
-
#define CONFIG_BOOT_RETRY_TIME 900
#define CONFIG_BOOT_RETRY_MIN 30
#define CONFIG_RESET_TO_RETRY
-#define CONFIG_83XX_CLKIN 66000000 /* in Hz */
-#define CONFIG_SYS_CLK_FREQ CONFIG_83XX_CLKIN
-
#define CONFIG_SYS_IMMR 0xF0000000
#define CONFIG_SYS_ACR_PIPE_DEP 3 /* Arbiter pipeline depth (0-3) */
#define CONFIG_SYS_ACR_RPTCNT 3 /* Arbiter repeat count (0-7) */
-/*
- * Hardware Reset Configuration Word
- * if CLKIN is 66.000MHz, then
- * CSB = 132MHz, CORE = 264MHz, DDRC = 264MHz, LBC = 132MHz
- */
-#define CONFIG_SYS_HRCW_LOW (0x20000000 /* reserved, must be set */ |\
- HRCWL_DDR_TO_SCB_CLK_2X1 |\
- HRCWL_CSB_TO_CLKIN_2X1 |\
- HRCWL_CORE_TO_CSB_2X1)
-
-#define CONFIG_SYS_HRCW_HIGH (HRCWH_PCI_HOST |\
- HRCWH_CORE_ENABLE |\
- HRCWH_FROM_0XFFF00100 |\
- HRCWH_BOOTSEQ_DISABLE |\
- HRCWH_SW_WATCHDOG_DISABLE |\
- HRCWH_ROM_LOC_LOCAL_8BIT |\
- HRCWH_RL_EXT_LEGACY |\
- HRCWH_TSEC1M_IN_MII |\
- HRCWH_TSEC2M_IN_MII |\
- HRCWH_BIG_ENDIAN)
-
#define CONFIG_SYS_SICRH 0x00000000
#define CONFIG_SYS_SICRL (SICRL_LBC | SICRL_SPI_D)
*/
#define CONFIG_TSEC1
#define CONFIG_TSEC2
-#define CONFIG_TSEC_ENET
-#define CONFIG_HARD_SPI
-#define CONFIG_HARD_I2C
/*
* NOR FLASH setup
*/
-#define CONFIG_SYS_FLASH_CFI
-#define CONFIG_FLASH_CFI_DRIVER
#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_8BIT
#define CONFIG_FLASH_SHOW_PROGRESS 50
-#define CONFIG_SYS_FLASH_USE_BUFFER_WRITE
#define CONFIG_SYS_FLASH_BASE 0xFF800000
#define CONFIG_SYS_FLASH_SIZE 8
-#define CONFIG_SYS_FLASH_PROTECTION
#define CONFIG_SYS_LBLAWBAR0_PRELIM CONFIG_SYS_FLASH_BASE
#define CONFIG_SYS_LBLAWAR0_PRELIM 0x80000016
#define CONFIG_SYS_I2C_RTC_ADDR 0x51
/*
- * SPI setup
- */
-#ifdef CONFIG_HARD_SPI
-#define CONFIG_MPC8XXX_SPI
-#define CONFIG_SYS_GPIO1_PRELIM
-#define CONFIG_SYS_GPIO1_DIR 0x00000001
-#define CONFIG_SYS_GPIO1_DAT 0x00000001
-#endif
-
-/*
* Ethernet setup
*/
#ifdef CONFIG_TSEC1
/*
* Serial Port
*/
-#define CONFIG_CONS_INDEX 1
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE 1
{300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 115200}
#define CONFIG_SYS_NS16550_COM1 (CONFIG_SYS_IMMR + 0x4500)
#define CONFIG_SYS_NS16550_COM2 (CONFIG_SYS_IMMR + 0x4600)
-#define CONFIG_SYS_NS16550_CLK (CONFIG_83XX_CLKIN * 2)
+#define CONFIG_SYS_NS16550_CLK (get_bus_freq(0))
#define CONFIG_HAS_FSL_DR_USB
#define CONFIG_SYS_SCCR_USBDRCM 3
/*
* U-Boot environment setup
*/
-#define CONFIG_CMD_NAND
-#define CONFIG_CMD_DATE
-#define CONFIG_CMDLINE_EDITING
-#define CONFIG_CMD_JFFS2
-#define CONFIG_BOOTP_SUBNETMASK
-#define CONFIG_BOOTP_GATEWAY
-#define CONFIG_BOOTP_HOSTNAME
-#define CONFIG_BOOTP_BOOTPATH
#define CONFIG_BOOTP_BOOTFILESIZE
/*
/*
* Environment Configuration
*/
-#define CONFIG_ENV_IS_IN_FLASH
#define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE \
+ CONFIG_SYS_MONITOR_LEN)
#define CONFIG_ENV_SIZE 0x20000
#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SIZE)
#define CONFIG_NETDEV eth1
-#define CONFIG_HOSTNAME ids8313
+#define CONFIG_HOSTNAME "ids8313"
#define CONFIG_ROOTPATH "/opt/eldk-4.2/ppc_6xx"
#define CONFIG_BOOTFILE "ids8313/uImage"
#define CONFIG_UBOOTPATH "ids8313/u-boot.bin"
#define CONFIG_FDTFILE "ids8313/ids8313.dtb"
#define CONFIG_LOADADDR 0x400000
-#define CONFIG_CMD_ENV_FLAGS
#define CONFIG_ENV_FLAGS_LIST_STATIC "ethaddr:mo,eth1addr:mo"
-#define CONFIG_BAUDRATE 115200
-
/* Initial Memory map for Linux*/
#define CONFIG_SYS_BOOTMAPSZ (256 << 20)
/*
* Miscellaneous configurable options
*/
-#define CONFIG_SYS_LONGHELP
#define CONFIG_SYS_CBSIZE 1024
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE \
- + sizeof(CONFIG_SYS_PROMPT)+16)
-#define CONFIG_SYS_MAXARGS 16
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
#define CONFIG_SYS_MEMTEST_START 0x00001000
#define CONFIG_SYS_MEMTEST_END 0x00C00000
#define CONFIG_SYS_LOAD_ADDR 0x100000
-#define CONFIG_MII
#define CONFIG_LOADS_ECHO
#define CONFIG_TIMESTAMP
#define CONFIG_PREBOOT "echo;" \
"echo Type \\\"run nfsboot\\\" " \
"to mount root filesystem over NFS;echo"
-#undef CONFIG_BOOTARGS
#define CONFIG_BOOTCOMMAND "run boot_cramfs"
#undef CONFIG_SYS_LOADS_BAUD_CHANGE
#define CONFIG_JFFS2_DEV "0"
/* mtdparts command line support */
-#define CONFIG_CMD_MTDPARTS
-#define CONFIG_FLASH_CFI_MTD
-#define CONFIG_MTD_DEVICE
-#define MTDIDS_DEFAULT "nor0=ff800000.flash,nand0=e1000000.flash"
-#define MTDPARTS_DEFAULT "mtdparts=ff800000.flash:7m(dum)," \
- "768k(BOOT-BIN)," \
- "128k(BOOT-ENV),128k(BOOT-REDENV);" \
- "e1000000.flash:-(ubi)"
#define CONFIG_EXTRA_ENV_SETTINGS \
"netdev=" __stringify(CONFIG_NETDEV) "\0" \
"${netmask}:${hostname}:${netdev}:off " \
"console=${console},${baudrate} ${othbootargs}\0" \
"addmtd=setenv bootargs ${bootargs} ${mtdparts}\0" \
- "mtdids=" MTDIDS_DEFAULT "\0" \
- "mtdparts=" MTDPARTS_DEFAULT "\0" \
+ "mtdids=" CONFIG_MTDIDS_DEFAULT "\0" \
+ "mtdparts=" CONFIG_MTDPARTS_DEFAULT "\0" \
"\0"
#define CONFIG_NFSBOOTCOMMAND \
"bootm ${loadaddr} - ${fdtaddr}"
/* UBI Support */
-#define CONFIG_CMD_NAND_TRIMFFS
-#define CONFIG_CMD_UBIFS
-#define CONFIG_RBTREE
-#define CONFIG_LZO
-#define CONFIG_MTD_PARTITIONS
-
-/* bootcount support */
-#define CONFIG_BOOTCOUNT_LIMIT
-#define CONFIG_BOOTCOUNT_I2C
-#define CONFIG_BOOTCOUNT_ALEN 1
-#define CONFIG_SYS_BOOTCOUNT_ADDR 0x9
-
-#define CONFIG_IMAGE_FORMAT_LEGACY
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA1
-#define CONFIG_SHA256
#endif /* __CONFIG_H */
projects / platform / kernel / u-boot.git / blobdiff