0e73239f568c86e0efe12af9e47abe3ac5ab5741
[platform/kernel/u-boot.git] / include / configs / socfpga_stratix10_socdk.h
1 /* SPDX-License-Identifier: GPL-2.0
2  *
3  * Copyright (C) 2017-2018 Intel Corporation <www.intel.com>
4  *
5  */
6
7 #ifndef __CONFIG_SOCFGPA_STRATIX10_H__
8 #define __CONFIG_SOCFGPA_STRATIX10_H__
9
10 #include <asm/arch/base_addr_s10.h>
11 #include <asm/arch/handoff_s10.h>
12
13 /*
14  * U-Boot general configurations
15  */
16 #define CONFIG_SYS_MONITOR_BASE         CONFIG_SYS_TEXT_BASE
17 #define CONFIG_LOADADDR                 0x2000000
18 #define CONFIG_SYS_LOAD_ADDR            CONFIG_LOADADDR
19 #define CONFIG_REMAKE_ELF
20 /* sysmgr.boot_scratch_cold4 & 5 (64bit) will be used for PSCI_CPU_ON call */
21 #define CPU_RELEASE_ADDR                0xFFD12210
22 #define CONFIG_SYS_CACHELINE_SIZE       64
23 #define CONFIG_SYS_MEM_RESERVE_SECURE   0       /* using OCRAM, not DDR */
24
25 /*
26  * U-Boot console configurations
27  */
28 #define CONFIG_SYS_MAXARGS              64
29 #define CONFIG_SYS_CBSIZE               2048
30 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + \
31                                         sizeof(CONFIG_SYS_PROMPT) + 16)
32 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
33
34 /* Extend size of kernel image for uncompression */
35 #define CONFIG_SYS_BOOTM_LEN            (32 * 1024 * 1024)
36
37 /*
38  * U-Boot run time memory configurations
39  */
40 #define CONFIG_SYS_INIT_RAM_ADDR        0xFFE00000
41 #define CONFIG_SYS_INIT_RAM_SIZE        0x40000
42 #define CONFIG_SYS_INIT_SP_ADDR         (CONFIG_SYS_INIT_RAM_ADDR  \
43                                         + CONFIG_SYS_INIT_RAM_SIZE \
44                                         - S10_HANDOFF_SIZE)
45 #define CONFIG_SYS_INIT_SP_OFFSET       (CONFIG_SYS_INIT_SP_ADDR)
46 #define CONFIG_SYS_MALLOC_LEN           (5 * 1024 * 1024)
47
48 /*
49  * U-Boot environment configurations
50  */
51 #define CONFIG_ENV_SIZE                 0x1000
52 #define CONFIG_SYS_MMC_ENV_DEV          0       /* device 0 */
53 #define CONFIG_ENV_OFFSET               512     /* just after the MBR */
54
55 /*
56  * QSPI support
57  */
58  #ifdef CONFIG_CADENCE_QSPI
59 /* Enable it if you want to use dual-stacked mode */
60 /*#define CONFIG_QSPI_RBF_ADDR          0x720000*/
61
62 /* Flash device info */
63 #define CONFIG_SF_DEFAULT_SPEED         (50000000)
64 #define CONFIG_SF_DEFAULT_MODE          (SPI_MODE_3 | SPI_RX_QUAD)
65 #define CONFIG_SF_DEFAULT_BUS           0
66 #define CONFIG_SF_DEFAULT_CS            0
67
68 /*#define CONFIG_ENV_IS_IN_SPI_FLASH*/
69 #ifdef CONFIG_ENV_IS_IN_SPI_FLASH
70 #undef CONFIG_ENV_OFFSET
71 #undef CONFIG_ENV_SIZE
72 #define CONFIG_ENV_OFFSET               0x710000
73 #define CONFIG_ENV_SIZE                 (4 * 1024)
74 #define CONFIG_ENV_SECT_SIZE            (4 * 1024)
75 #endif /* CONFIG_ENV_IS_IN_SPI_FLASH */
76
77 #ifndef CONFIG_SPL_BUILD
78 #define CONFIG_MTD_DEVICE
79 #define CONFIG_MTD_PARTITIONS
80 #define MTDIDS_DEFAULT                  "nor0=ff705000.spi.0"
81 #endif /* CONFIG_SPL_BUILD */
82
83 #ifndef __ASSEMBLY__
84 unsigned int cm_get_qspi_controller_clk_hz(void);
85 #define CONFIG_CQSPI_REF_CLK            cm_get_qspi_controller_clk_hz()
86 #endif
87
88 #endif /* CONFIG_CADENCE_QSPI */
89
90 /*
91  * Boot arguments passed to the boot command. The value of
92  * CONFIG_BOOTARGS goes into the environment value "bootargs".
93  * Do note the value will override also the chosen node in FDT blob.
94  */
95 #define CONFIG_BOOTARGS "earlycon"
96 #define CONFIG_BOOTCOMMAND "run fatscript; run mmcload;run linux_qspi_enable;" \
97                            "run mmcboot"
98
99 #define CONFIG_EXTRA_ENV_SETTINGS \
100         "loadaddr=" __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \
101         "bootfile=Image\0" \
102         "fdt_addr=8000000\0" \
103         "fdtimage=socfpga_stratix10_socdk.dtb\0" \
104         "mmcroot=/dev/mmcblk0p2\0" \
105         "mmcboot=setenv bootargs " CONFIG_BOOTARGS \
106                 " root=${mmcroot} rw rootwait;" \
107                 "booti ${loadaddr} - ${fdt_addr}\0" \
108         "mmcload=mmc rescan;" \
109                 "load mmc 0:1 ${loadaddr} ${bootfile};" \
110                 "load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \
111         "linux_qspi_enable=if sf probe; then " \
112                 "echo Enabling QSPI at Linux DTB...;" \
113                 "fdt addr ${fdt_addr}; fdt resize;" \
114                 "fdt set /soc/spi@ff8d2000 status okay;" \
115                 "fdt set /soc/clkmgr/clocks/qspi_clk clock-frequency " \
116                 " ${qspi_clock}; fi; \0" \
117         "scriptaddr=0x02100000\0" \
118         "scriptfile=u-boot.scr\0" \
119         "fatscript=if fatload mmc 0:1 ${scriptaddr} ${scriptfile};" \
120                    "then source ${scriptaddr}; fi\0"
121
122 /*
123  * Generic Interrupt Controller Definitions
124  */
125 #define CONFIG_GICV2
126
127 /*
128  * External memory configurations
129  */
130 #define PHYS_SDRAM_1                    0x0
131 #define PHYS_SDRAM_1_SIZE               (1 * 1024 * 1024 * 1024)
132 #define CONFIG_SYS_SDRAM_BASE           0
133 #define CONFIG_SYS_MEMTEST_START        0
134 #define CONFIG_SYS_MEMTEST_END          PHYS_SDRAM_1_SIZE - 0x200000
135
136 /*
137  * SDRAM controller
138  */
139 #define CONFIG_ALTERA_SDRAM
140
141 /*
142  * Serial / UART configurations
143  */
144 #define CONFIG_SYS_NS16550_CLK          100000000
145 #define CONFIG_SYS_NS16550_MEM32
146
147 /*
148  * Timer & watchdog configurations
149  */
150 #define COUNTER_FREQUENCY               400000000
151
152 /*
153  * SDMMC configurations
154  */
155 #ifdef CONFIG_CMD_MMC
156 #define CONFIG_SYS_MMC_MAX_BLK_COUNT    256
157 #endif
158 /*
159  * Flash configurations
160  */
161 #define CONFIG_SYS_MAX_FLASH_BANKS      1
162
163 /* Ethernet on SoC (EMAC) */
164 #if defined(CONFIG_CMD_NET)
165 #define CONFIG_DW_ALTDESCRIPTOR
166 #endif /* CONFIG_CMD_NET */
167
168 /*
169  * L4 Watchdog
170  */
171 #ifdef CONFIG_SPL_BUILD
172 #define CONFIG_HW_WATCHDOG
173 #define CONFIG_DESIGNWARE_WATCHDOG
174 #define CONFIG_DW_WDT_BASE              SOCFPGA_L4WD0_ADDRESS
175 #ifndef __ASSEMBLY__
176 unsigned int cm_get_l4_sys_free_clk_hz(void);
177 #define CONFIG_DW_WDT_CLOCK_KHZ         (cm_get_l4_sys_free_clk_hz() / 1000)
178 #endif
179 #define CONFIG_WATCHDOG_TIMEOUT_MSECS   3000
180 #endif
181
182 /*
183  * SPL memory layout
184  *
185  * On chip RAM
186  * 0xFFE0_0000 ...... Start of OCRAM
187  * SPL code, rwdata
188  * empty space
189  * 0xFFEx_xxxx ...... Top of stack (grows down)
190  * 0xFFEy_yyyy ...... Global Data
191  * 0xFFEz_zzzz ...... Malloc prior relocation (size CONFIG_SYS_MALLOC_F_LEN)
192  * 0xFFE3_F000 ...... Hardware handdoff blob (size 4KB)
193  * 0xFFE3_FFFF ...... End of OCRAM
194  *
195  * SDRAM
196  * 0x0000_0000 ...... Start of SDRAM_1
197  * unused / empty space for image loading
198  * Size 64MB   ...... MALLOC (size CONFIG_SYS_SPL_MALLOC_SIZE)
199  * Size 1MB    ...... BSS (size CONFIG_SPL_BSS_MAX_SIZE)
200  * 0x8000_0000 ...... End of SDRAM_1 (assume 2GB)
201  *
202  */
203 #define CONFIG_SPL_TARGET               "spl/u-boot-spl.hex"
204 #define CONFIG_SPL_TEXT_BASE            CONFIG_SYS_INIT_RAM_ADDR
205 #define CONFIG_SPL_MAX_SIZE             CONFIG_SYS_INIT_RAM_SIZE
206 #define CONFIG_SPL_STACK                CONFIG_SYS_INIT_SP_ADDR
207 #define CONFIG_SPL_BSS_MAX_SIZE         0x100000        /* 1 MB */
208 #define CONFIG_SPL_BSS_START_ADDR       (PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE \
209                                         - CONFIG_SPL_BSS_MAX_SIZE)
210 #define CONFIG_SYS_SPL_MALLOC_SIZE      (CONFIG_SYS_MALLOC_LEN)
211 #define CONFIG_SYS_SPL_MALLOC_START     (CONFIG_SPL_BSS_START_ADDR \
212                                         - CONFIG_SYS_SPL_MALLOC_SIZE)
213 #define CONFIG_SYS_SPI_U_BOOT_OFFS      0x3C00000
214
215 /* SPL SDMMC boot support */
216 #define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION      1
217 #define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME         "u-boot.img"
218
219 #endif  /* __CONFIG_H */