include/configs/novena.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Configuration settings for the Novena U-Boot.
   4  *
   5  * Copyright (C) 2014 Marek Vasut <marex@denx.de>
   6  */
   7
   8 #ifndef __CONFIG_H
   9 #define __CONFIG_H
  10
  11 /* System configurations */
  12 #define CONFIG_KEYBOARD
  13
  14 #include "mx6_common.h"
  15
  16 /* U-Boot Commands */
  17
  18 /* U-Boot general configurations */
  19
  20 /* U-Boot environment */
  21 /*
  22  * Environment is on MMC, starting at offset 512KiB from start of the card.
  23  * Please place first partition at offset 1MiB from the start of the card
  24  * as recommended by GNU/fdisk. See below for details:
  25  * http://homepage.ntlworld.com./jonathan.deboynepollard/FGA/disc-partition-alignment.html
  26  */
  27
  28 /* Booting Linux */
  29 #define CONFIG_BOOTFILE                 "fitImage"
  30 #define CONFIG_HOSTNAME                 "novena"
  31
  32 /* Physical Memory Map */
  33 #define PHYS_SDRAM                      MMDC0_ARB_BASE_ADDR
  34
  35 #define CONFIG_SYS_SDRAM_BASE           PHYS_SDRAM
  36 #define CONFIG_SYS_INIT_RAM_ADDR        IRAM_BASE_ADDR
  37 #define CONFIG_SYS_INIT_RAM_SIZE        IRAM_SIZE
  38
  39 #define CONFIG_SYS_INIT_SP_OFFSET \
  40         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
  41 #define CONFIG_SYS_INIT_SP_ADDR \
  42         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
  43
  44 /* SPL */
  45 #include "imx6_spl.h"                   /* common IMX6 SPL configuration */
  46
  47 /* Ethernet Configuration */
  48 #ifdef CONFIG_SPL_BUILD
  49 #undef CONFIG_DM_ETH
  50 #endif
  51
  52 /* I2C */
  53 #define CONFIG_I2C_MULTI_BUS
  54 #define CONFIG_SYS_SPD_BUS_NUM          0
  55
  56 /* I2C EEPROM */
  57
  58 /* MMC Configs */
  59 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
  60 #define CONFIG_SYS_FSL_USDHC_NUM        2
  61
  62 /* PCI express */
  63 #ifdef CONFIG_CMD_PCI
  64 #define CONFIG_PCI_SCAN_SHOW
  65 #define CONFIG_PCIE_IMX
  66 #define CONFIG_PCIE_IMX_PERST_GPIO      IMX_GPIO_NR(3, 29)
  67 #define CONFIG_PCIE_IMX_POWER_GPIO      IMX_GPIO_NR(7, 12)
  68 #endif
  69
  70 /* PMIC */
  71 #define CONFIG_POWER
  72 #define CONFIG_POWER_I2C
  73 #define CONFIG_POWER_PFUZE100
  74 #define CONFIG_POWER_PFUZE100_I2C_ADDR  0x08
  75
  76 /* SATA Configs */
  77 #define CONFIG_LBA48
  78
  79 /* UART */
  80 #define CONFIG_MXC_UART_BASE            UART2_BASE
  81
  82 /* USB Configs */
  83 #ifdef CONFIG_CMD_USB
  84 #define CONFIG_USB_MAX_CONTROLLER_COUNT 2
  85 #define CONFIG_MXC_USB_PORTSC           (PORT_PTS_UTMI | PORT_PTS_PTW)
  86 #define CONFIG_MXC_USB_FLAGS            0
  87 /* Gadget part */
  88 #define CONFIG_USBD_HS
  89 #endif
  90
  91 /* Video output */
  92 #define CONFIG_VIDEO_LOGO
  93 #define CONFIG_IMX_HDMI
  94 #define CONFIG_IMX_VIDEO_SKIP
  95
  96 /* Extra U-Boot environment. */
  97 #ifndef CONFIG_SPL_BUILD
  98 #define CONFIG_EXTRA_ENV_SETTINGS                                       \
  99         "fdt_high=0xffffffff\0"                                         \
 100         "initrd_high=0xffffffff\0"                                      \
 101         "consdev=ttymxc1\0"                                             \
 102         "baudrate=115200\0"                                             \
 103         "bootdev=/dev/mmcblk0p1\0"                                      \
 104         "rootdev=/dev/mmcblk0p2\0"                                      \
 105         "netdev=eth0\0"                                                 \
 106         "kernel_addr_r="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"           \
 107         "pxefile_addr_r="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"          \
 108         "scriptaddr="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"                      \
 109         "ramdisk_addr_r=0x28000000\0"                                   \
 110         "fdt_addr_r=0x18000000\0"                                       \
 111         "fdtfile=imx6q-novena.dtb\0"                                    \
 112         "stdout=serial,vidconsole\0"                                    \
 113         "stderr=serial,vidconsole\0"                                    \
 114         "addcons="                                                      \
 115                 "setenv bootargs ${bootargs} "                          \
 116                 "console=${consdev},${baudrate}\0"                      \
 117         "addip="                                                        \
 118                 "setenv bootargs ${bootargs} "                          \
 119                 "ip=${ipaddr}:${serverip}:${gatewayip}:"                \
 120                         "${netmask}:${hostname}:${netdev}:off\0"        \
 121         "addmisc="                                                      \
 122                 "setenv bootargs ${bootargs} ${miscargs}\0"             \
 123         "addargs=run addcons addmisc\0"                                 \
 124         "mmcload="                                                      \
 125                 "mmc rescan ; "                                         \
 126                 "ext4load mmc 0:1 ${kernel_addr_r} ${bootfile}\0"       \
 127         "netload="                                                      \
 128                 "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0"       \
 129         "miscargs=nohlt panic=1\0"                                      \
 130         "mmcargs=setenv bootargs root=${rootdev} rw rootwait\0"         \
 131         "nfsargs="                                                      \
 132                 "setenv bootargs root=/dev/nfs rw "                     \
 133                         "nfsroot=${serverip}:${rootpath},v3,tcp\0"      \
 134         "mmc_mmc="                                                      \
 135                 "run mmcload mmcargs addargs ; "                        \
 136                 "bootm ${kernel_addr_r}\0"                              \
 137         "mmc_nfs="                                                      \
 138                 "run mmcload nfsargs addip addargs ; "                  \
 139                 "bootm ${kernel_addr_r}\0"                              \
 140         "net_mmc="                                                      \
 141                 "run netload mmcargs addargs ; "                        \
 142                 "bootm ${kernel_addr_r}\0"                              \
 143         "net_nfs="                                                      \
 144                 "run netload nfsargs addip addargs ; "                  \
 145                 "bootm ${kernel_addr_r}\0"                              \
 146         "update_sd_spl_filename=SPL\0"                                  \
 147         "update_sd_uboot_filename=u-boot.img\0"                         \
 148         "update_sd_firmware="   /* Update the SD firmware partition */  \
 149                 "if mmc rescan ; then "                                 \
 150                 "if dhcp ${update_sd_spl_filename} ; then "             \
 151                 "mmc write ${loadaddr} 2 0x200 ; "                      \
 152                 "fi ; "                                                 \
 153                 "if dhcp ${update_sd_uboot_filename} ; then "           \
 154                 "fatwrite mmc 0:1 ${loadaddr} u-boot.img ${filesize} ; "\
 155                 "fi ; "                                                 \
 156                 "fi\0"                                                  \
 157         BOOTENV
 158
 159 #define BOOT_TARGET_DEVICES(func) \
 160         func(MMC, mmc, 0) \
 161         func(USB, usb, 0) \
 162         func(SATA, sata, 0) \
 163         func(PXE, pxe, na) \
 164         func(DHCP, dhcp, na)
 165
 166 #include <config_distro_bootcmd.h>
 167
 168 #else
 169 #define CONFIG_EXTRA_ENV_SETTINGS
 170 #endif /* CONFIG_SPL_BUILD */
 171
 172 #endif                          /* __CONFIG_H */