Convert CONFIG_SYS_FLASH_CFI_WIDTH to Kconfig
[platform/kernel/u-boot.git] / include / configs / M5235EVB.h
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Configuation settings for the Freescale MCF5329 FireEngine board.
4  *
5  * Copyright (C) 2004-2007 Freescale Semiconductor, Inc.
6  * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
7  */
8
9 /*
10  * board/config.h - configuration options, board specific
11  */
12
13 #ifndef _M5235EVB_H
14 #define _M5235EVB_H
15
16 /*
17  * High Level Configuration Options
18  * (easy to change)
19  */
20
21 #define CONFIG_SYS_UART_PORT            (0)
22
23 #define CONFIG_WATCHDOG_TIMEOUT 5000    /* timeout in milliseconds, max timeout is 6.71sec */
24
25 #ifdef CONFIG_MCFFEC
26 #       define CONFIG_SYS_DISCOVER_PHY
27 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
28 #       ifndef CONFIG_SYS_DISCOVER_PHY
29 #               define FECDUPLEX        FULL
30 #               define FECSPEED         _100BASET
31 #       endif                   /* CONFIG_SYS_DISCOVER_PHY */
32 #endif
33
34 /* I2C */
35 #define CONFIG_SYS_I2C_PINMUX_REG       (gpio->par_qspi)
36 #define CONFIG_SYS_I2C_PINMUX_CLR       ~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK)
37 #define CONFIG_SYS_I2C_PINMUX_SET       (GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA)
38
39 /* this must be included AFTER the definition of CONFIG COMMANDS (if any) */
40 #ifdef CONFIG_MCFFEC
41 #       define CONFIG_IPADDR    192.162.1.2
42 #       define CONFIG_NETMASK   255.255.255.0
43 #       define CONFIG_SERVERIP  192.162.1.1
44 #       define CONFIG_GATEWAYIP 192.162.1.1
45 #endif                          /* FEC_ENET */
46
47 #define CONFIG_HOSTNAME         "M5235EVB"
48 #define CONFIG_EXTRA_ENV_SETTINGS               \
49         "netdev=eth0\0"                         \
50         "loadaddr=10000\0"                      \
51         "u-boot=u-boot.bin\0"                   \
52         "load=tftp ${loadaddr) ${u-boot}\0"     \
53         "upd=run load; run prog\0"              \
54         "prog=prot off ffe00000 ffe3ffff;"      \
55         "era ffe00000 ffe3ffff;"                \
56         "cp.b ${loadaddr} ffe00000 ${filesize};"\
57         "save\0"                                \
58         ""
59
60 #define CONFIG_PRAM             512     /* 512 KB */
61
62 #define CONFIG_SYS_CLK                  75000000
63 #define CONFIG_SYS_CPU_CLK              CONFIG_SYS_CLK * 2
64
65 #define CONFIG_SYS_MBAR         0x40000000
66
67 /*
68  * Low Level Configuration Settings
69  * (address mappings, register initial values, etc.)
70  * You should know what you are doing if you make changes here.
71  */
72 /*-----------------------------------------------------------------------
73  * Definitions for initial stack pointer and data area (in DPRAM)
74  */
75 #define CONFIG_SYS_INIT_RAM_ADDR        0x20000000
76 #define CONFIG_SYS_INIT_RAM_SIZE        0x10000 /* Size of used area in internal SRAM */
77 #define CONFIG_SYS_INIT_RAM_CTRL        0x21
78 #define CONFIG_SYS_GBL_DATA_OFFSET      (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10)
79 #define CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
80
81 /*-----------------------------------------------------------------------
82  * Start addresses for the final memory configuration
83  * (Set up by the startup code)
84  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
85  */
86 #define CONFIG_SYS_SDRAM_BASE           0x00000000
87 #define CONFIG_SYS_SDRAM_SIZE           16      /* SDRAM size in MB */
88
89 #define CONFIG_SYS_MONITOR_LEN          (256 << 10)     /* Reserve 256 kB for Monitor */
90
91 /*
92  * For booting Linux, the board info and command line data
93  * have to be in the first 8 MB of memory, since this is
94  * the maximum mapped by the Linux kernel during initialization ??
95  */
96 /* Initial Memory map for Linux */
97 #define CONFIG_SYS_BOOTMAPSZ            (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
98 #define CONFIG_SYS_BOOTM_LEN            (CONFIG_SYS_SDRAM_SIZE << 20)
99
100 /*-----------------------------------------------------------------------
101  * FLASH organization
102  */
103 #ifdef CONFIG_SYS_FLASH_CFI
104 #       define CONFIG_SYS_FLASH_SIZE            0x800000        /* Max size that the board might have */
105 #       define CONFIG_SYS_MAX_FLASH_SECT        137     /* max number of sectors on one chip */
106 #endif
107
108 #define CONFIG_SYS_FLASH_BASE           (CONFIG_SYS_CS0_BASE)
109
110 /* Configuration for environment
111  * Environment is embedded in u-boot in the second sector of the flash
112  */
113
114 #define LDS_BOARD_TEXT \
115         . = DEFINED(env_offset) ? env_offset : .; \
116         env/embedded.o(.text);
117
118 /*-----------------------------------------------------------------------
119  * Cache Configuration
120  */
121
122 #define ICACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
123                                          CONFIG_SYS_INIT_RAM_SIZE - 8)
124 #define DCACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
125                                          CONFIG_SYS_INIT_RAM_SIZE - 4)
126 #define CONFIG_SYS_ICACHE_INV           (CF_CACR_CINV)
127 #define CONFIG_SYS_CACHE_ACR0           (CONFIG_SYS_SDRAM_BASE | \
128                                          CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
129                                          CF_ACR_EN | CF_ACR_SM_ALL)
130 #define CONFIG_SYS_CACHE_ICACR          (CF_CACR_CENB | CF_CACR_DISD | \
131                                          CF_CACR_CEIB | CF_CACR_DCM | \
132                                          CF_CACR_EUSP)
133
134 /*-----------------------------------------------------------------------
135  * Chipselect bank definitions
136  */
137 /*
138  * CS0 - NOR Flash 1, 2, 4, or 8MB
139  * CS1 - Available
140  * CS2 - Available
141  * CS3 - Available
142  * CS4 - Available
143  * CS5 - Available
144  * CS6 - Available
145  * CS7 - Available
146  */
147 #ifdef CONFIG_NORFLASH_PS32BIT
148 #       define CONFIG_SYS_CS0_BASE      0xFFC00000
149 #       define CONFIG_SYS_CS0_MASK      0x003f0001
150 #       define CONFIG_SYS_CS0_CTRL      0x00001D00
151 #else
152 #       define CONFIG_SYS_CS0_BASE      0xFFE00000
153 #       define CONFIG_SYS_CS0_MASK      0x001f0001
154 #       define CONFIG_SYS_CS0_CTRL      0x00001D80
155 #endif
156
157 #endif                          /* _M5329EVB_H */