configs/ls1021atwr_sdcard_qspi_defconfig

   1 CONFIG_ARM=y
   2 CONFIG_SKIP_LOWLEVEL_INIT=y
   3 CONFIG_SPL_SKIP_LOWLEVEL_INIT=y
   4 CONFIG_COUNTER_FREQUENCY=12500000
   5 CONFIG_TARGET_LS1021ATWR=y
   6 CONFIG_TEXT_BASE=0x82000000
   7 CONFIG_SYS_MALLOC_LEN=0x1020000
   8 CONFIG_SPL_LIBCOMMON_SUPPORT=y
   9 CONFIG_SPL_LIBGENERIC_SUPPORT=y
  10 CONFIG_NR_DRAM_BANKS=1
  11 CONFIG_ENV_SIZE=0x20000
  12 CONFIG_ENV_OFFSET=0x300000
  13 CONFIG_SYS_I2C_MXC_I2C1=y
  14 CONFIG_SYS_I2C_MXC_I2C2=y
  15 CONFIG_SYS_I2C_MXC_I2C3=y
  16 CONFIG_DM_GPIO=y
  17 CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart"
  18 CONFIG_SPL_TEXT_BASE=0x10000000
  19 CONFIG_SPL_MMC=y
  20 CONFIG_SPL_SERIAL=y
  21 CONFIG_SPL=y
  22 CONFIG_SYS_LOAD_ADDR=0x82000000
  23 CONFIG_AHCI=y
  24 CONFIG_LAYERSCAPE_NS_ACCESS=y
  25 CONFIG_PCIE1=y
  26 CONFIG_PCIE2=y
  27 CONFIG_SYS_MEMTEST_START=0x80000000
  28 CONFIG_SYS_MEMTEST_END=0x9fffffff
  29 CONFIG_DISTRO_DEFAULTS=y
  30 CONFIG_SYS_MONITOR_LEN=1048576
  31 CONFIG_FIT=y
  32 CONFIG_FIT_VERBOSE=y
  33 CONFIG_OF_BOARD_SETUP=y
  34 CONFIG_OF_STDOUT_VIA_ALIAS=y
  35 CONFIG_RAMBOOT_PBL=y
  36 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021atwr/ls102xa_pbi.cfg"
  37 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021atwr/ls102xa_rcw_sd_qspi.cfg"
  38 CONFIG_SD_BOOT=y
  39 CONFIG_SD_BOOT_QSPI=y
  40 CONFIG_BOOTDELAY=3
  41 CONFIG_USE_BOOTARGS=y
  42 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0"
  43 CONFIG_BOOTCOMMAND="run distro_bootcmd; run qspi_bootcmd; env exists secureboot && esbc_halt"
  44 CONFIG_SILENT_CONSOLE=y
  45 CONFIG_SYS_CONSOLE_IS_IN_ENV=y
  46 CONFIG_ARCH_MISC_INIT=y
  47 CONFIG_MISC_INIT_R=y
  48 CONFIG_ID_EEPROM=y
  49 CONFIG_SYS_EEPROM_BUS_NUM=1
  50 CONFIG_SPL_MAX_SIZE=0x1a000
  51 CONFIG_SPL_PAD_TO=0x1c000
  52 CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
  53 CONFIG_SPL_BSS_START_ADDR=0x80100000
  54 CONFIG_SPL_BSS_MAX_SIZE=0x80000
  55 CONFIG_SPL_FSL_PBL=y
  56 # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
  57 CONFIG_SPL_STACK=0x1001d000
  58 CONFIG_SYS_SPL_MALLOC=y
  59 CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y
  60 CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x82100000
  61 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
  62 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
  63 CONFIG_SPL_ENV_SUPPORT=y
  64 CONFIG_SPL_I2C=y
  65 CONFIG_SPL_MPC8XXX_INIT_DDR=y
  66 CONFIG_SPL_WATCHDOG=y
  67 CONFIG_SYS_CBSIZE=256
  68 CONFIG_SYS_PBSIZE=276
  69 CONFIG_SYS_BOOTM_LEN=0x4000000
  70 CONFIG_CMD_GREPENV=y
  71 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
  72 CONFIG_CMD_MEMINFO=y
  73 CONFIG_CMD_MEMTEST=y
  74 CONFIG_CMD_GPIO=y
  75 CONFIG_CMD_GPT=y
  76 CONFIG_CMD_I2C=y
  77 CONFIG_CMD_MMC=y
  78 CONFIG_CMD_USB=y
  79 # CONFIG_SPL_EFI_PARTITION is not set
  80 CONFIG_OF_CONTROL=y
  81 CONFIG_ENV_OVERWRITE=y
  82 CONFIG_ENV_IS_IN_MMC=y
  83 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
  84 CONFIG_USE_ETHPRIME=y
  85 CONFIG_ETHPRIME="ethernet@2d10000"
  86 CONFIG_SATA=y
  87 CONFIG_SATA_CEVA=y
  88 CONFIG_FSL_CAAM=y
  89 CONFIG_MPC8XXX_GPIO=y
  90 CONFIG_DM_I2C=y
  91 CONFIG_SPL_SYS_I2C_LEGACY=y
  92 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
  93 CONFIG_SYS_I2C_EEPROM_ADDR=0x53
  94 CONFIG_FSL_ESDHC=y
  95 CONFIG_MTD=y
  96 CONFIG_SPI_FLASH_ATMEL=y
  97 CONFIG_SPI_FLASH_STMICRO=y
  98 CONFIG_PHY_ATHEROS=y
  99 CONFIG_DM_MDIO=y
 100 CONFIG_PHY_GIGE=y
 101 CONFIG_E1000=y
 102 CONFIG_MII=y
 103 CONFIG_TSEC_ENET=y
 104 CONFIG_NVME_PCI=y
 105 CONFIG_PCI=y
 106 CONFIG_PCIE_LAYERSCAPE_RC=y
 107 CONFIG_DM_SCSI=y
 108 CONFIG_SYS_NS16550=y
 109 CONFIG_SPI=y
 110 CONFIG_DM_SPI=y
 111 CONFIG_FSL_DSPI=y
 112 CONFIG_FSL_QSPI=y
 113 CONFIG_USB=y
 114 CONFIG_USB_XHCI_HCD=y
 115 CONFIG_USB_XHCI_DWC3=y