1 Intel(R) Minnowboard Max {#minnowmax}
2 ========================
3 MinnowBoard MAX is an open hardware embedded board designed with the Intel(R)
4 Atom(TM) E38xx series SOC (Fromerly Bay Trail).
6 For product overview and faq see
7 http://www.minnowboard.org/faq-minnowboard-max/
9 For technical details see http://www.elinux.org/Minnowboard:MinnowMax
13 mraa has only been tested with 64 bit firmware version 0.73 or later.
17 The low speed I/O connector supported as per table below. This assumes default
18 BIOS settings, as they are not dynamcially detected If any changes are mode
19 (Device Manager -> System Setup -> South Cluster -> LPSS & CSS) them mraa calls
20 will not behave as expected.
22 Documentation shows i2c on bus #5, ACPI shows it on bus #6, but driver uses bus
25 **SPI operation is not currently supported**
27 | MRAA Number | Physical Pin | Function | Sysfs GPIO | Notes |
28 |-------------|---------------|------------|------------|----------------------|
33 | 5 | 5 | SPI_CS | 220 | SPI (not supported) |
34 | 6 | 6 | UART1_TXD | 225 | UART1 |
35 | 7 | 7 | SPI_MISO | 221 | SPI (not supported) |
36 | 8 | 8 | UART1_RXD | 224 | UART1 |
37 | 9 | 9 | SPI_MOSI | 222 | SPI (not supported) |
38 | 10 | 10 | UART1_CTS | 227 | GPIO |
39 | 11 | 11 | SPI_CLK | 223 | SPI (not supported) |
40 | 12 | 12 | UART1_RTS | 226 | GPIO |
41 | 13 | 13 | I2C_SCL | 243 | /dev/i2c-7 |
42 | 14 | 14 | I2S_CLK | 216 | GPIO |
43 | 15 | 15 | I2C_SDA | 242 | /dev/i2c-7 |
44 | 16 | 16 | I2S_FRM | 217 | GPIO |
45 | 17 | 17 | UART2_TXD | 229 | UART2 |
46 | 18 | 18 | I2S_DO | 219 | GPIO |
47 | 19 | 19 | UART2_RXD | 228 | UART2 |
48 | 20 | 20 | I2S_DI | 218 | GPIO |
49 | 21 | 21 | GPIO_S5_0 | 82 | GPIO |
50 | 22 | 22 | PWM0 | 248 | PWM Chip 0 Channel 0 |
51 | 23 | 23 | GPIO_S5_1 | 83 | GPIO |
52 | 24 | 24 | PWM1 | 249 | PWM Chip 1 Channel 0 |
53 | 25 | 25 | S5_4 | 84 | GPIO |
54 | 26 | 26 | IBL_8254 | 208 | GPIO |