config BITBANGMII
bool "Bit-banged ethernet MII management channel support"
+config BITBANGMII_MULTI
+ bool "Enable the multi bus support"
+ depends on BITBANGMII
+
config MV88E6352_SWITCH
bool "Marvell 88E6352 switch support"
config PHYLIB_10G
bool "Generic 10G PHY support"
+config PHY_ADIN
+ bool "Analog Devices Industrial Ethernet PHYs"
+ help
+ Add support for configuring RGMII on Analog Devices ADIN PHYs.
+
menuconfig PHY_AQUANTIA
bool "Aquantia Ethernet PHYs support"
select PHY_GIGE
Enable support for NXP C45 TJA11XX PHYs.
Currently supports only the TJA1103 PHY.
+config PHY_NXP_TJA11XX
+ bool "NXP TJA11XX Ethernet PHYs support"
+ help
+ Currently supports the NXP TJA1100 and TJA1101 PHY.
+
config PHY_REALTEK
bool "Realtek Ethernet PHYs support"
---help---
Adds support for the TI DP83867 1Gbit PHY.
+config PHY_TI_DP83869
+ select PHY_TI
+ bool "Texas Instruments Ethernet DP83869 PHY support"
+ ---help---
+ Adds support for the TI DP83869 1Gbit PHY.
+
config PHY_TI_GENERIC
select PHY_TI
bool "Texas Instruments Generic Ethernet PHYs support"
as bridge between MAC connected over GMII and external phy that
is connected over RGMII interface.
+config PHY_ETHERNET_ID
+ bool "Read ethernet PHY id"
+ depends on DM_GPIO
+ default y if ZYNQ_GEM
+ help
+ Enable this config to read ethernet phy id from the phy node of DT
+ and create a phy device using id.
+
config PHY_FIXED
bool "Fixed-Link PHY"
depends on DM_ETH
depends on DM_ETH
endif #PHYLIB
+
+config FSL_MEMAC
+ bool "NXP mEMAC PHY support"
+
+config SYS_MEMAC_LITTLE_ENDIAN
+ bool "mEMAC is access in little endian mode"
+ depends on FSL_MEMAC || FSL_LS_MDIO
+
+config PHY_RESET_DELAY
+ int "Extra delay after reset before MII register access"
+ default 0
+ help
+ Some PHYs need extra delay after reset before any MII register access
+ is possible. For such PHY, set this option to the usec delay
+ required.