Convert CONFIG_USE_PREBOOT and CONFIG_PREBOOT to Kconfig

[platform/kernel/u-boot.git] / include / configs / socfpga_vining_fpga.h

diff --git a/include/configs/socfpga_vining_fpga.h b/include/configs/socfpga_vining_fpga.h
index c5555e6..232536a 100644 (file)
--- a/include/configs/socfpga_vining_fpga.h
+++ b/include/configs/socfpga_vining_fpga.h
@@ -1,74 +1,28 @@
+/* SPDX-License-Identifier: GPL-2.0+ */
 /*
  * Copyright (C) 2015 Marek Vasut <marex@denx.de>
- *
- * SPDX-License-Identifier:    GPL-2.0+
  */
 #ifndef __CONFIG_SAMTEC_VINING_FPGA_H__
 #define __CONFIG_SAMTEC_VINING_FPGA_H__
 
 #include <asm/arch/base_addr_ac5.h>
 
-/* U-Boot Commands */
-#define CONFIG_SYS_NO_FLASH
-#define CONFIG_DOS_PARTITION
-#define CONFIG_FAT_WRITE
-#define CONFIG_HW_WATCHDOG
-
-#define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_LED
-
 /* Memory configurations */
 #define PHYS_SDRAM_1_SIZE              0x40000000      /* 1GiB on VINING_FPGA */
 
 /* Booting Linux */
 #define CONFIG_BOOTFILE                "openwrt-socfpga-socfpga_cyclone5_vining_fpga-fit-uImage.itb"
-#define CONFIG_BOOTARGS                "console=ttyS0," __stringify(CONFIG_BAUDRATE)
 #define CONFIG_BOOTCOMMAND     "run selboot"
 #define CONFIG_LOADADDR                0x01000000
 #define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
 
-/* I2C EEPROM */
-#ifdef CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_EEPROM_ADDR             0x50
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN         1
-#define CONFIG_SYS_I2C_EEPROM_BUS              0
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS      3
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS  70
-#endif
-
-/*
- * Status LEDs:
- *   0 ... Top Green
- *   1 ... Top Red
- *   2 ... Bottom Green
- *   3 ... Bottom Red
- */
-#define CONFIG_STATUS_LED
-#define CONFIG_GPIO_LED
-#define CONFIG_BOARD_SPECIFIC_LED
-#define STATUS_LED_BIT         48
-#define STATUS_LED_STATE       STATUS_LED_OFF
-#define STATUS_LED_PERIOD      (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BIT1                53
-#define STATUS_LED_STATE1      STATUS_LED_OFF
-#define STATUS_LED_PERIOD1     (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BIT2                54
-#define STATUS_LED_STATE2      STATUS_LED_OFF
-#define STATUS_LED_PERIOD2     (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BIT3                65
-#define STATUS_LED_STATE3      STATUS_LED_OFF
-#define STATUS_LED_PERIOD3     (CONFIG_SYS_HZ / 2)
-
 /* Ethernet on SoC (EMAC) */
 #if defined(CONFIG_CMD_NET)
 #define CONFIG_BOOTP_SEND_HOSTNAME
-/* PHY */
-#define CONFIG_PHY_MICREL
-#define CONFIG_PHY_MICREL_KSZ9021
 #endif
 
 /* Extra Environment */
-#define CONFIG_HOSTNAME                        socfpga_vining_fpga
+#define CONFIG_HOSTNAME                        "socfpga_vining_fpga"
 
 /*
  * Active LOW GPIO buttons:
@@ -79,16 +33,6 @@
  *  if button B is not pressed, boot normal Linux system immediatelly
  *  if button B is pressed, wait $bootdelay and boot recovery system
  */
-#define CONFIG_PREBOOT                                         \
-       "setenv hostname vining-${unit_serial} ; "              \
-       "setenv PS1 \"${unit_ident} (${unit_serial}) => \" ; "  \
-       "if gpio input 78 ; then "                      \
-               "setenv bootdelay 10 ; "                \
-               "setenv boottype rcvr ; "               \
-       "else "                                         \
-               "setenv bootdelay 5 ; "                 \
-               "setenv boottype norm ; "               \
-       "fi"
 
 #define CONFIG_EXTRA_ENV_SETTINGS \
        "verify=n\0" \
@@ -191,20 +135,8 @@
                        "run ubi_ubi ; "                                \
                "else echo \"Unsupported boot mode: \"${bootmode} ; "   \
                "fi\0"                                                  \
+               "socfpga_legacy_reset_compat=1\0"
 
-#define CONFIG_CMD_UBIFS
-#define CONFIG_RBTREE
-#define CONFIG_LZO
-#define MTDPARTS_DEFAULT                       \
-       "mtdparts=ff705000.spi.0:"              \
-               "1m(u-boot),"                   \
-               "64k(env1),"                    \
-               "64k(env2),"                    \
-               "256k(samtec1),"                \
-               "256k(samtec2),"                \
-               "-(rcvrfs);"    /* Recovery */  \
-
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_SYS_REDUNDAND_ENVIRONMENT
 #define CONFIG_ENV_SIZE_REDUND         CONFIG_ENV_SIZE
 #define CONFIG_ENV_SECT_SIZE           (64 * 1024)
@@ -212,9 +144,6 @@
 #define CONFIG_ENV_OFFSET_REDUND       \
        (CONFIG_ENV_OFFSET + CONFIG_ENV_SECT_SIZE)
 
-#define CONFIG_MISC_INIT_R
-#define CONFIG_BOARD_LATE_INIT
-
 /* Support changing the prompt string */
 #define CONFIG_CMDLINE_PS_SUPPORT