net: eepro100: Add Kconfig entries

[platform/kernel/u-boot.git] / include / configs / sbc8641d.h

diff --git a/include/configs/sbc8641d.h b/include/configs/sbc8641d.h
index d777e7a..66c1f35 100644 (file)
--- a/include/configs/sbc8641d.h
+++ b/include/configs/sbc8641d.h
@@ -45,7 +45,6 @@
 #define CONFIG_ENV_OVERWRITE
 
 #define CONFIG_BAT_RW          1       /* Use common BAT rw code */
-#define CONFIG_HIGH_BATS       1       /* High BATs supported and enabled */
 
 #undef CONFIG_SPD_EEPROM               /* Do not use SPD EEPROM for DDR setup*/
 #undef CONFIG_DDR_ECC                  /* only for ECC DDR module */
@@ -70,8 +69,6 @@
 #endif
 
 #undef CONFIG_SYS_DRAM_TEST                            /* memory test, takes time */
-#define CONFIG_SYS_MEMTEST_START       0x00200000      /* memtest region */
-#define CONFIG_SYS_MEMTEST_END         0x00400000
 
 /*
  * Base addresses -- Note these are effective addresses where the
@@ -206,11 +203,8 @@
 #define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE    /* start of monitor */
 #define CONFIG_SYS_MONITOR_BASE_EARLY   0xfff00000     /* early monitor loc */
 
-#define CONFIG_FLASH_CFI_DRIVER
-#define CONFIG_SYS_FLASH_CFI
 #define CONFIG_SYS_WRITE_SWAPPED_DATA
 #define CONFIG_SYS_FLASH_EMPTY_INFO
-#define CONFIG_SYS_FLASH_PROTECTION
 
 #undef CONFIG_CLOCKS_IN_MHZ
 
@@ -282,7 +276,6 @@
 
 #define CONFIG_PCI_SCAN_SHOW            /* show pci devices on startup */
 
-#undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
 
 #if !defined(CONFIG_PCI_PNP)
@@ -430,9 +423,6 @@
 /*
  * Environment
  */
-#define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN)
-#define CONFIG_ENV_SECT_SIZE   0x20000 /* 128k(one sector) for env */
-#define CONFIG_ENV_SIZE                0x2000
 
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */