+++ /dev/null
-/*
- * (C) Copyright 2003
- * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
- *
- * SPDX-License-Identifier: GPL-2.0+
- */
-
-/*
- * This file contains the configuration parameters for the dbau1x00 board.
- */
-
-#ifndef __CONFIG_H
-#define __CONFIG_H
-
-#define CONFIG_PB1X00 1
-#define CONFIG_SOC_AU1X00 1 /* alchemy series cpu */
-
-#define CONFIG_DISPLAY_BOARDINFO
-
-#ifdef CONFIG_PB1000
-#define CONFIG_SOC_AU1000 1
-#else
-#ifdef CONFIG_PB1100
-#define CONFIG_SOC_AU1100 1
-#else
-#ifdef CONFIG_PB1500
-#define CONFIG_SOC_AU1500 1
-#else
-#error "No valid board set"
-#endif
-#endif
-#endif
-
-#define CONFIG_BOOTDELAY 2 /* autoboot after 2 seconds */
-
-#define CONFIG_BAUDRATE 115200
-
-#define CONFIG_TIMESTAMP /* Print image info with timestamp */
-#undef CONFIG_BOOTARGS
-
-#define CONFIG_EXTRA_ENV_SETTINGS \
- "addmisc=setenv bootargs ${bootargs} " \
- "console=ttyS0,${baudrate} " \
- "panic=1\0" \
- "bootfile=/vmlinux.img\0" \
- "load=tftp 80500000 ${u-boot}\0" \
- ""
-/* Boot from NFS root */
-#define CONFIG_BOOTCOMMAND "bootp; setenv bootargs root=/dev/nfs rw nfsroot=${serverip}:${rootpath} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}::off; bootm"
-
-/*
- * Miscellaneous configurable options
- */
-#define CONFIG_SYS_LONGHELP /* undef to save memory */
-#define CONFIG_SYS_PROMPT "Pb1x00 # " /* Monitor Command Prompt */
-#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
-#define CONFIG_SYS_MAXARGS 16 /* max number of command args*/
-
-#define CONFIG_SYS_MALLOC_LEN 128*1024
-
-#define CONFIG_SYS_BOOTPARAMS_LEN 128*1024
-
-#define CONFIG_SYS_MIPS_TIMER_FREQ 396000000
-
-#define CONFIG_SYS_SDRAM_BASE 0x80000000 /* Cached addr */
-
-#define CONFIG_SYS_LOAD_ADDR 0x81000000 /* default load address */
-
-#define CONFIG_SYS_MEMTEST_START 0x80100000
-#undef CONFIG_SYS_MEMTEST_START
-#define CONFIG_SYS_MEMTEST_START 0x80200000
-#define CONFIG_SYS_MEMTEST_END 0x83800000
-
-/*-----------------------------------------------------------------------
- * FLASH and environment organization
- */
-#define CONFIG_SYS_MAX_FLASH_BANKS 2 /* max number of memory banks */
-#define CONFIG_SYS_MAX_FLASH_SECT (128) /* max number of sectors on one chip */
-
-#define PHYS_FLASH_1 0xbec00000 /* Flash Bank #1 */
-#define PHYS_FLASH_2 0xbfc00000 /* Flash Bank #2 */
-
-/* The following #defines are needed to get flash environment right */
-#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE
-#define CONFIG_SYS_MONITOR_LEN (192 << 10)
-
-#define CONFIG_SYS_INIT_SP_OFFSET 0x4000000
-
-/* We boot from this flash, selected with dip switch */
-#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_2
-
-/* timeout values are in ticks */
-#define CONFIG_SYS_FLASH_ERASE_TOUT (2 * CONFIG_SYS_HZ) /* Timeout for Flash Erase */
-#define CONFIG_SYS_FLASH_WRITE_TOUT (2 * CONFIG_SYS_HZ) /* Timeout for Flash Write */
-
-#define CONFIG_ENV_IS_NOWHERE 1
-
-/* Address and size of Primary Environment Sector */
-#define CONFIG_ENV_ADDR 0xB0030000
-#define CONFIG_ENV_SIZE 0x10000
-
-#define CONFIG_FLASH_16BIT
-
-#define CONFIG_NR_DRAM_BANKS 2
-
-
-#define CONFIG_MEMSIZE_IN_BYTES
-
-
-/*---USB -------------------------------------------*/
-#if 0
-#define CONFIG_USB_OHCI
-#define CONFIG_USB_STORAGE
-#define CONFIG_DOS_PARTITION
-#endif
-
-/*---ATA PCMCIA ------------------------------------*/
-#if 0
-#define CONFIG_SYS_PCMCIA_MEM_SIZE 0x4000000 /* Offset to slot 1 FIXME!!! */
-#define CONFIG_SYS_PCMCIA_MEM_ADDR 0x20000000
-#define CONFIG_PCMCIA_SLOT_A
-
-#define CONFIG_ATAPI 1
-#define CONFIG_MAC_PARTITION 1
-
-/* We run CF in "true ide" mode or a harddrive via pcmcia */
-#define CONFIG_IDE_PCMCIA 1
-
-/* We only support one slot for now */
-#define CONFIG_SYS_IDE_MAXBUS 1 /* max. 1 IDE bus */
-#define CONFIG_SYS_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */
-
-#undef CONFIG_IDE_LED /* LED for ide not supported */
-#undef CONFIG_IDE_RESET /* reset for ide not supported */
-
-#define CONFIG_SYS_ATA_IDE0_OFFSET 0x0000
-
-#define CONFIG_SYS_ATA_BASE_ADDR CONFIG_SYS_PCMCIA_MEM_ADDR
-
-/* Offset for data I/O */
-#define CONFIG_SYS_ATA_DATA_OFFSET 8
-
-/* Offset for normal register accesses */
-#define CONFIG_SYS_ATA_REG_OFFSET 0
-
-/* Offset for alternate registers */
-#define CONFIG_SYS_ATA_ALT_OFFSET 0x0100
-
-#endif
-/*-----------------------------------------------------------------------
- * Cache Configuration
- */
-#define CONFIG_SYS_DCACHE_SIZE 16384
-#define CONFIG_SYS_ICACHE_SIZE 16384
-#define CONFIG_SYS_CACHELINE_SIZE 32
-
-
-/*
- * BOOTP options
- */
-#define CONFIG_BOOTP_BOOTFILESIZE
-#define CONFIG_BOOTP_BOOTPATH
-#define CONFIG_BOOTP_GATEWAY
-#define CONFIG_BOOTP_HOSTNAME
-
-
-/*
- * Command line configuration.
- */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_PING
-
-#undef CONFIG_CMD_SAVEENV
-#undef CONFIG_CMD_FAT
-#undef CONFIG_CMD_FLASH
-#undef CONFIG_CMD_FPGA
-#undef CONFIG_CMD_IDE
-#undef CONFIG_CMD_LOADS
-#undef CONFIG_CMD_RUN
-#undef CONFIG_CMD_LOADB
-#undef CONFIG_CMD_ELF
-#undef CONFIG_CMD_BDI
-#undef CONFIG_CMD_BEDBUG
-
-#endif /* __CONFIG_H */
projects / platform / kernel / u-boot.git / blobdiff