+++ /dev/null
-/*
- * Configuation settings for the Renesas Solutions ECOVEC board
- *
- * Copyright (C) 2009 - 2011 Renesas Solutions Corp.
- * Copyright (C) 2009 Kuninori Morimoto <morimoto.kuninori@renesas.com>
- * Copyright (C) 2010, 2011 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
- *
- * SPDX-License-Identifier: GPL-2.0+
- */
-
-#ifndef __ECOVEC_H
-#define __ECOVEC_H
-
-/*
- * Address Interface BusWidth
- *-----------------------------------------
- * 0x0000_0000 U-Boot 16bit
- * 0x0004_0000 Linux romImage 16bit
- * 0x0014_0000 MTD for Linux 16bit
- * 0x0400_0000 Internal I/O 16/32bit
- * 0x0800_0000 DRAM 32bit
- * 0x1800_0000 MFI 16bit
- */
-
-#define CONFIG_CPU_SH7724 1
-
-#define CONFIG_ECOVEC_ROMIMAGE_ADDR 0xA0040000
-#define CONFIG_SYS_TEXT_BASE 0x8FFC0000
-
-#define CONFIG_DISPLAY_BOARDINFO
-#undef CONFIG_SHOW_BOOT_PROGRESS
-
-/* I2C */
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_SH
-#define CONFIG_SYS_I2C_SLAVE 0x7F
-#define CONFIG_SYS_I2C_SH_NUM_CONTROLLERS 2
-#define CONFIG_SYS_I2C_SH_BASE0 0xA4470000
-#define CONFIG_SYS_I2C_SH_SPEED0 100000
-#define CONFIG_SYS_I2C_SH_BASE1 0xA4750000
-#define CONFIG_SYS_I2C_SH_SPEED1 100000
-#define CONFIG_SH_I2C_DATA_HIGH 4
-#define CONFIG_SH_I2C_DATA_LOW 5
-#define CONFIG_SH_I2C_CLOCK 41666666
-
-/* Ether */
-#define CONFIG_SH_ETHER_USE_PORT (0)
-#define CONFIG_SH_ETHER_PHY_ADDR (0x1f)
-#define CONFIG_PHY_SMSC 1
-#define CONFIG_BITBANGMII
-#define CONFIG_BITBANGMII_MULTI
-#define CONFIG_SH_ETHER_PHY_MODE PHY_INTERFACE_MODE_MII
-
-/* USB / R8A66597 */
-#define CONFIG_USB_R8A66597_HCD
-#define CONFIG_R8A66597_BASE_ADDR 0xA4D80000
-#define CONFIG_R8A66597_XTAL 0x0000 /* 12MHz */
-#define CONFIG_R8A66597_LDRV 0x8000 /* 3.3V */
-#define CONFIG_R8A66597_ENDIAN 0x0000 /* little */
-#define CONFIG_SUPERH_ON_CHIP_R8A66597
-
-/* undef to save memory */
-#define CONFIG_SYS_LONGHELP
-/* Monitor Command Prompt */
-/* Buffer size for Console output */
-#define CONFIG_SYS_PBSIZE 256
-/* List of legal baudrate settings for this board */
-#define CONFIG_SYS_BAUDRATE_TABLE { 115200 }
-
-/* SCIF */
-#define CONFIG_SCIF 1
-#define CONFIG_CONS_SCIF0 1
-
-/* Suppress display of console information at boot */
-
-/* SDRAM */
-#define CONFIG_SYS_SDRAM_BASE (0x88000000)
-#define CONFIG_SYS_SDRAM_SIZE (256 * 1024 * 1024)
-#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)
-
-#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
-#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + 200 * 1024 * 1024)
-/* Enable alternate, more extensive, memory test */
-#undef CONFIG_SYS_ALT_MEMTEST
-/* Scratch address used by the alternate memory test */
-#undef CONFIG_SYS_MEMTEST_SCRATCH
-
-/* Enable temporary baudrate change while serial download */
-#undef CONFIG_SYS_LOADS_BAUD_CHANGE
-
-/* FLASH */
-#define CONFIG_FLASH_CFI_DRIVER 1
-#define CONFIG_SYS_FLASH_CFI
-#undef CONFIG_SYS_FLASH_QUIET_TEST
-#define CONFIG_SYS_FLASH_EMPTY_INFO
-#define CONFIG_SYS_FLASH_BASE (0xA0000000)
-#define CONFIG_SYS_MAX_FLASH_SECT 512
-
-/* if you use all NOR Flash , you change dip-switch. Please see Manual. */
-#define CONFIG_SYS_MAX_FLASH_BANKS 1
-#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
-
-/* Timeout for Flash erase operations (in ms) */
-#define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000)
-/* Timeout for Flash write operations (in ms) */
-#define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000)
-/* Timeout for Flash set sector lock bit operations (in ms) */
-#define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000)
-/* Timeout for Flash clear lock bit operations (in ms) */
-#define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000)
-
-/*
- * Use hardware flash sectors protection instead
- * of U-Boot software protection
- */
-#undef CONFIG_SYS_FLASH_PROTECTION
-#undef CONFIG_SYS_DIRECT_FLASH_TFTP
-
-/* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */
-#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE)
-/* Monitor size */
-#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
-/* Size of DRAM reserved for malloc() use */
-#define CONFIG_SYS_MALLOC_LEN (256 * 1024)
-#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
-
-/* ENV setting */
-#define CONFIG_ENV_OVERWRITE 1
-#define CONFIG_ENV_SECT_SIZE (128 * 1024)
-#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE)
-#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
-/* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
-#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)
-#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE)
-
-/* Board Clock */
-#define CONFIG_SYS_CLK_FREQ 41666666
-#define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ
-#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
-#define CONFIG_SYS_TMU_CLK_DIV 4
-
-#endif /* __ECOVEC_H */
projects / platform / kernel / u-boot.git / blobdiff