Convert CONFIG_SYS_LOAD_ADDR to Kconfig

[platform/kernel/u-boot.git] / configs / brppt1_nand_defconfig

diff --git a/configs/brppt1_nand_defconfig b/configs/brppt1_nand_defconfig
index 97b69c1..1db660f 100644 (file)
--- a/configs/brppt1_nand_defconfig
+++ b/configs/brppt1_nand_defconfig
@@ -1,6 +1,6 @@
 CONFIG_ARM=y
 CONFIG_ARCH_OMAP2PLUS=y
-CONFIG_SPL_GPIO_SUPPORT=y
+CONFIG_SPL_GPIO=y
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_SYS_MALLOC_F_LEN=0x2000
@@ -14,6 +14,7 @@ CONFIG_TARGET_BRPPT1=y
 CONFIG_SPL_SERIAL_SUPPORT=y
 CONFIG_SPL=y
 # CONFIG_EXPERT is not set
+CONFIG_SYS_LOAD_ADDR=0x80000000
 # CONFIG_FIT is not set
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_BOOTDELAY=0
@@ -30,12 +31,12 @@ CONFIG_ARCH_MISC_INIT=y
 CONFIG_SPL_SYS_MALLOC_SIMPLE=y
 CONFIG_SPL_SEPARATE_BSS=y
 # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
-CONFIG_SPL_I2C_SUPPORT=y
+CONFIG_SPL_I2C=y
 CONFIG_SPL_NAND_DRIVERS=y
 CONFIG_SPL_NAND_ECC=y
 CONFIG_SPL_NAND_BASE=y
-CONFIG_SPL_POWER_SUPPORT=y
-CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SPL_POWER=y
+CONFIG_SPL_WATCHDOG=y
 CONFIG_SPL_YMODEM_SUPPORT=y
 CONFIG_HUSH_PARSER=y
 CONFIG_CMD_BOOTZ=y
@@ -80,7 +81,6 @@ CONFIG_DM=y
 CONFIG_SPL_DM=y
 CONFIG_SPL_DM_SEQ_ALIAS=y
 # CONFIG_OF_TRANSLATE is not set
-CONFIG_BLK=y
 CONFIG_BOOTCOUNT_LIMIT=y
 CONFIG_DM_I2C=y
 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
@@ -95,7 +95,6 @@ CONFIG_DM_ETH=y
 CONFIG_DRIVER_TI_CPSW=y
 CONFIG_DM_SERIAL=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_MUSB_HOST=y
 CONFIG_USB_MUSB_GADGET=y
 CONFIG_USB_MUSB_TI=y