ppc4xx: Big cleanup of PPC4xx defines

[platform/kernel/u-boot.git] / board / korat / korat.c

diff --git a/board/korat/korat.c b/board/korat/korat.c
index 8328ba3..3d4d149 100644 (file)
--- a/board/korat/korat.c
+++ b/board/korat/korat.c
@@ -81,8 +81,8 @@ int board_early_init_f(void)
        korat_buzzer(0);
 #endif
 
-       mtdcr(ebccfga, xbcfg);
-       mtdcr(ebccfgd, 0xb8400000);
+       mtdcr(EBC0_CFGADDR, EBC0_CFG);
+       mtdcr(EBC0_CFGDATA, 0xb8400000);
 
        /*
         * Setup the interrupt controller polarities, triggers, etc.
@@ -157,8 +157,8 @@ int board_early_init_f(void)
        mtsdr(SDR0_PFC1, sdr0_pfc1);
 
        /* PCI arbiter enabled */
-       mfsdr(sdr_pci0, reg);
-       mtsdr(sdr_pci0, 0x80000000 | reg);
+       mfsdr(SDR0_PCI0, reg);
+       mtsdr(SDR0_PCI0, 0x80000000 | reg);
 
        return 0;
 }
@@ -359,12 +359,12 @@ int misc_init_r(void)
        gd->bd->bi_flashstart = CONFIG_SYS_FLASH1_TOP - flash1_size;
        gd->bd->bi_flashoffset = 0;
 
-       mtdcr(ebccfga, pb1cr);
-       pbcr = mfdcr(ebccfgd);
+       mtdcr(EBC0_CFGADDR, PB1CR);
+       pbcr = mfdcr(EBC0_CFGDATA);
        size_val = ffs(flash1_size) - 21;
        pbcr = (pbcr & 0x0001ffff) | gd->bd->bi_flashstart | (size_val << 17);
-       mtdcr(ebccfga, pb1cr);
-       mtdcr(ebccfgd, pbcr);
+       mtdcr(EBC0_CFGADDR, PB1CR);
+       mtdcr(EBC0_CFGDATA, pbcr);
 
        /*
         * Re-check to get correct base address
@@ -378,12 +378,12 @@ int misc_init_r(void)
        gd->bd->bi_flashoffset =
                CONFIG_ENV_ADDR_REDUND + CONFIG_ENV_SECT_SIZE - CONFIG_SYS_FLASH1_ADDR;
 
-       mtdcr(ebccfga, pb1cr);
-       pbcr = mfdcr(ebccfgd);
+       mtdcr(EBC0_CFGADDR, PB1CR);
+       pbcr = mfdcr(EBC0_CFGDATA);
        size_val = ffs(gd->bd->bi_flashsize - CONFIG_SYS_FLASH0_SIZE) - 21;
        pbcr = (pbcr & 0x0001ffff) | gd->bd->bi_flashstart | (size_val << 17);
-       mtdcr(ebccfga, pb1cr);
-       mtdcr(ebccfgd, pbcr);
+       mtdcr(EBC0_CFGADDR, PB1CR);
+       mtdcr(EBC0_CFGDATA, pbcr);
 
        /* Monitor protection ON by default */
 #if defined(CONFIG_KORAT_PERMANENT)
@@ -552,8 +552,8 @@ int misc_init_r(void)
         * This fix will make the MAL burst disabling patch for the Linux
         * EMAC driver obsolete.
         */
-       reg = mfdcr(plb4_acr) & ~PLB4_ACR_WRP;
-       mtdcr(plb4_acr, reg);
+       reg = mfdcr(PLB4_ACR) & ~PLB4_ACR_WRP;
+       mtdcr(PLB4_ACR, reg);
 
        set_serial_number();
        set_mac_addresses();
@@ -620,35 +620,35 @@ int pci_pre_init(struct pci_controller *hose)
         * Set priority for all PLB3 devices to 0.
         * Set PLB3 arbiter to fair mode.
         */
-       mfsdr(sdr_amp1, addr);
-       mtsdr(sdr_amp1, (addr & 0x000000FF) | 0x0000FF00);
-       addr = mfdcr(plb3_acr);
-       mtdcr(plb3_acr, addr | 0x80000000);
+       mfsdr(SD0_AMP1, addr);
+       mtsdr(SD0_AMP1, (addr & 0x000000FF) | 0x0000FF00);
+       addr = mfdcr(PLB3_ACR);
+       mtdcr(PLB3_ACR, addr | 0x80000000);
 
        /*
         * Set priority for all PLB4 devices to 0.
         */
-       mfsdr(sdr_amp0, addr);
-       mtsdr(sdr_amp0, (addr & 0x000000FF) | 0x0000FF00);
-       addr = mfdcr(plb4_acr) | 0xa0000000;    /* Was 0x8---- */
-       mtdcr(plb4_acr, addr);
+       mfsdr(SD0_AMP0, addr);
+       mtsdr(SD0_AMP0, (addr & 0x000000FF) | 0x0000FF00);
+       addr = mfdcr(PLB4_ACR) | 0xa0000000;    /* Was 0x8---- */
+       mtdcr(PLB4_ACR, addr);
 
        /*
         * Set Nebula PLB4 arbiter to fair mode.
         */
        /* Segment0 */
-       addr = (mfdcr(plb0_acr) & ~plb0_acr_ppm_mask) | plb0_acr_ppm_fair;
-       addr = (addr & ~plb0_acr_hbu_mask) | plb0_acr_hbu_enabled;
-       addr = (addr & ~plb0_acr_rdp_mask) | plb0_acr_rdp_4deep;
-       addr = (addr & ~plb0_acr_wrp_mask) | plb0_acr_wrp_2deep;
-       mtdcr(plb0_acr, addr);
+       addr = (mfdcr(PLB0_ACR) & ~PLB0_ACR_PPM_MASK) | PLB0_ACR_PPM_FAIR;
+       addr = (addr & ~PLB0_ACR_HBU_MASK) | PLB0_ACR_HBU_ENABLED;
+       addr = (addr & ~PLB0_ACR_RDP_MASK) | PLB0_ACR_RDP_4DEEP;
+       addr = (addr & ~PLB0_ACR_WRP_MASK) | PLB0_ACR_WRP_2DEEP;
+       mtdcr(PLB0_ACR, addr);
 
        /* Segment1 */
-       addr = (mfdcr(plb1_acr) & ~plb1_acr_ppm_mask) | plb1_acr_ppm_fair;
-       addr = (addr & ~plb1_acr_hbu_mask) | plb1_acr_hbu_enabled;
-       addr = (addr & ~plb1_acr_rdp_mask) | plb1_acr_rdp_4deep;
-       addr = (addr & ~plb1_acr_wrp_mask) | plb1_acr_wrp_2deep;
-       mtdcr(plb1_acr, addr);
+       addr = (mfdcr(PLB1_ACR) & ~PLB1_ACR_PPM_MASK) | PLB1_ACR_PPM_FAIR;
+       addr = (addr & ~PLB1_ACR_HBU_MASK) | PLB1_ACR_HBU_ENABLED;
+       addr = (addr & ~PLB1_ACR_RDP_MASK) | PLB1_ACR_RDP_4DEEP;
+       addr = (addr & ~PLB1_ACR_WRP_MASK) | PLB1_ACR_WRP_2DEEP;
+       mtdcr(PLB1_ACR, addr);
 
 #if defined(CONFIG_PCI_PNP)
        hose->fixup_irq = korat_pci_fixup_irq;