From e654f19165483adfc30eeabe69a1efc23182bf0e Mon Sep 17 00:00:00 2001 From: Andrew Jeffery Date: Wed, 2 Aug 2017 14:15:28 +0930 Subject: [PATCH] dt-bindings: watchdog: aspeed: External reset signal properties For the AST2500 and compatible watchdog controllers the external reset signal can be configured for push-pull or open-drain drive types, and in the case of push-pull driving, active low or high. Signed-off-by: Andrew Jeffery Acked-by: Rob Herring Reviewed-by: Guenter Roeck Signed-off-by: Guenter Roeck Signed-off-by: Wim Van Sebroeck --- Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt b/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt index 2b34ce9..c5077a1 100644 --- a/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt +++ b/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt @@ -33,10 +33,18 @@ Optional properties: - none: No reset is performed on timeout. Assumes another watchdog engine is responsible for this. + - aspeed,alt-boot: If property is present then boot from alternate block. - aspeed,external-signal: If property is present then signal is sent to external reset counter (only WDT1 and WDT2). If not specified no external signal is sent. - - aspeed,alt-boot: If property is present then boot from alternate block. + - aspeed,ext-pulse-duration: External signal pulse duration in microseconds + +Optional properties for AST2500-compatible watchdogs: + - aspeed,ext-push-pull: If aspeed,external-signal is present, set the pin's + drive type to push-pull. The default is open-drain. + - aspeed,ext-active-high: If aspeed,external-signal is present and and the pin + is configured as push-pull, then set the pulse + polarity to active-high. The default is active-low. Example: -- 2.7.4