From e509e59477083b09e808c8c20562983d34172bb9 Mon Sep 17 00:00:00 2001 From: Ben Greear Date: Fri, 16 Jun 2017 10:37:44 +0300 Subject: [PATCH] ath10k: use complete VHT chan width for 160MHz workaround The ath10k firmware doesn't announce its VHT channel width capabilities in the vht_cap information from the "service ready event" arguments. The driver must therefore check whether the 160MHz short GI bit is set and whether the driver still doesn't set the bits for the 160/80+80 MHz capabilities. The two bits for the channel width are a two bit integer and not two separate bits which cannot be parsed without the knowledge of the other bit. Using IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ (b10..) as a mask for this task doesn't make any sense. The correct mask for the VHT channel width should be used instead to make this check more readable. Signed-off-by: Ben Greear [sven.eckelmann@openmesh.com: separate 160Mhz workaround cleanup, add commit message] Signed-off-by: Sven Eckelmann Signed-off-by: Kalle Valo --- drivers/net/wireless/ath/ath10k/mac.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 48418f9..51551c1 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -4391,7 +4391,7 @@ static struct ieee80211_sta_vht_cap ath10k_create_vht_cap(struct ath10k *ar) * mode until that's resolved. */ if ((ar->vht_cap_info & IEEE80211_VHT_CAP_SHORT_GI_160) && - !(ar->vht_cap_info & IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ)) + (ar->vht_cap_info & IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_MASK) == 0) vht_cap.cap |= IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ; mcs_map = 0; -- 2.7.4