From b6b5e8a691185606dfffff3198c89e3b4fd9d4f6 Mon Sep 17 00:00:00 2001 From: Claudiu Manoil Date: Thu, 7 Dec 2017 18:44:23 +0200 Subject: [PATCH] gianfar: Disable EEE autoneg by default This controller does not support EEE, but it may connect to a PHY which supports EEE and advertises EEE by default, while its link partner also advertises EEE. If this happens, the PHY enters low power mode when the traffic rate is low and causes packet loss. This patch disables EEE advertisement by default for any PHY that gianfar connects to, to prevent the above unwanted outcome. Signed-off-by: Shaohui Xie Tested-by: Yangbo Lu Signed-off-by: Claudiu Manoil Reviewed-by: Andrew Lunn Signed-off-by: David S. Miller --- drivers/net/ethernet/freescale/gianfar.c | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c index 81a73af0df31..7f837006bb6a 100644 --- a/drivers/net/ethernet/freescale/gianfar.c +++ b/drivers/net/ethernet/freescale/gianfar.c @@ -1792,6 +1792,7 @@ static int init_phy(struct net_device *dev) GFAR_SUPPORTED_GBIT : 0; phy_interface_t interface; struct phy_device *phydev; + struct ethtool_eee edata; priv->oldlink = 0; priv->oldspeed = 0; @@ -1816,6 +1817,10 @@ static int init_phy(struct net_device *dev) /* Add support for flow control, but don't advertise it by default */ phydev->supported |= (SUPPORTED_Pause | SUPPORTED_Asym_Pause); + /* disable EEE autoneg, EEE not supported by eTSEC */ + memset(&edata, 0, sizeof(struct ethtool_eee)); + phy_ethtool_set_eee(phydev, &edata); + return 0; } -- 2.34.1