From b650a8806e1ba0315fbeda8b45c9e53d73abbb6f Mon Sep 17 00:00:00 2001 From: Benjamin Rood Date: Mon, 2 Nov 2015 15:42:29 -0500 Subject: [PATCH] pm80xx: wait a minimum of 500ms before issuing commands to SPCv The documentation for the 8070 and 8072 SPCv chip explicitly states that a minimum of 500ms must elapse before issuing commands, otherwise the SPCv may not process them and the firmware may get into an unrecoverable state requiring a reboot. While the Linux guys will probably think this is 'racy', it is called out in the chip documentation and inserting this delay makes power management function properly. Signed-off-by: Benjamin Rood Reviewed-by: Jack Wang Reviewed-by: Hannes Reinecke Signed-off-by: Martin K. Petersen --- drivers/scsi/pm8001/pm8001_init.c | 13 +++++++++++++ 1 file changed, 13 insertions(+) diff --git a/drivers/scsi/pm8001/pm8001_init.c b/drivers/scsi/pm8001/pm8001_init.c index 7ce7ea3..d147c41 100644 --- a/drivers/scsi/pm8001/pm8001_init.c +++ b/drivers/scsi/pm8001/pm8001_init.c @@ -1243,6 +1243,19 @@ static int pm8001_pci_resume(struct pci_dev *pdev) for (i = 1; i < pm8001_ha->number_of_intr; i++) PM8001_CHIP_DISP->interrupt_enable(pm8001_ha, i); } + + /* Chip documentation for the 8070 and 8072 SPCv */ + /* states that a 500ms minimum delay is required */ + /* before issuing commands. Otherwise, the firmare */ + /* will enter an unrecoverable state. */ + + if (pm8001_ha->chip_id == chip_8070 || + pm8001_ha->chip_id == chip_8072) { + mdelay(500); + } + + /* Spin up the PHYs */ + pm8001_ha->flags = PM8001F_RUN_TIME; for (i = 0; i < pm8001_ha->chip->n_phy; i++) { pm8001_ha->phy[i].enable_completion = &completion; -- 2.7.4