From 9feb786876c711a11002dd35cae6c814abe354e9 Mon Sep 17 00:00:00 2001 From: Jean-Michel Hautbois Date: Tue, 13 Feb 2018 12:48:53 -0500 Subject: [PATCH] media: dt-bindings: media: adv7604: Extend bindings to allow specifying slave map addresses The ADV7604 has thirteen 256-byte maps that can be accessed via the main I2C ports. Each map has it own I2C address and acts as a standard slave device on the I2C bus. Extend the device tree node bindings to be able to override the default addresses so that address conflicts with other devices on the same bus may be resolved at the board description level. [Kieran: Re-adapted for mainline] Signed-off-by: Jean-Michel Hautbois Signed-off-by: Kieran Bingham Reviewed-by: Rob Herring Reviewed-by: Laurent Pinchart Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab --- .../devicetree/bindings/media/i2c/adv7604.txt | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/media/i2c/adv7604.txt b/Documentation/devicetree/bindings/media/i2c/adv7604.txt index 9cbd92e..dcf57e7 100644 --- a/Documentation/devicetree/bindings/media/i2c/adv7604.txt +++ b/Documentation/devicetree/bindings/media/i2c/adv7604.txt @@ -13,7 +13,11 @@ Required Properties: - "adi,adv7611" for the ADV7611 - "adi,adv7612" for the ADV7612 - - reg: I2C slave address + - reg: I2C slave addresses + The ADV76xx has up to thirteen 256-byte maps that can be accessed via the + main I2C ports. Each map has it own I2C address and acts as a standard + slave device on the I2C bus. The main address is mandatory, others are + optional and revert to defaults if not specified. - hpd-gpios: References to the GPIOs that control the HDMI hot-plug detection pins, one per HDMI input. The active flag indicates the GPIO @@ -35,6 +39,11 @@ Optional Properties: - reset-gpios: Reference to the GPIO connected to the device's reset pin. - default-input: Select which input is selected after reset. + - reg-names : Names of maps with programmable addresses. + It can contain any map needing a non-default address. + Possible maps names are : + "main", "avlink", "cec", "infoframe", "esdp", "dpp", "afe", + "rep", "edid", "hdmi", "test", "cp", "vdp" Optional Endpoint Properties: @@ -52,7 +61,12 @@ Example: hdmi_receiver@4c { compatible = "adi,adv7611"; - reg = <0x4c>; + /* + * The edid page will be accessible @ 0x66 on the I2C bus. All + * other maps will retain their default addresses. + */ + reg = <0x4c>, <0x66>; + reg-names "main", "edid"; reset-gpios = <&ioexp 0 GPIO_ACTIVE_LOW>; hpd-gpios = <&ioexp 2 GPIO_ACTIVE_HIGH>; -- 2.7.4