From 8fb5c147b7deb1282255fe081eefc983563b99e0 Mon Sep 17 00:00:00 2001 From: Roger Quadros Date: Thu, 7 Oct 2021 15:08:23 +0300 Subject: [PATCH] dt-bindings: mtd: Remove gpmc-nor.txt There is no GPMC NOR compatible or device driver. GPMC is just a bus interface over which standard (CFI/JEDC) NOR Flash chips can be attached. For NOR chip bindings, please refer to Documentation/devicetree/bindings/mtd/mtd-physmap.yaml Signed-off-by: Roger Quadros Acked-by: Rob Herring Signed-off-by: Tony Lindgren --- Documentation/devicetree/bindings/mtd/gpmc-nor.txt | 98 ---------------------- 1 file changed, 98 deletions(-) delete mode 100644 Documentation/devicetree/bindings/mtd/gpmc-nor.txt diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt deleted file mode 100644 index 2133be0..0000000 --- a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt +++ /dev/null @@ -1,98 +0,0 @@ -Device tree bindings for NOR flash connect to TI GPMC - -NOR flash connected to the TI GPMC (found on OMAP boards) are represented as -child nodes of the GPMC controller with a name of "nor". - -All timing relevant properties as well as generic GPMC child properties are -explained in a separate documents. Please refer to -Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt - -Required properties: -- bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and - 16-bit devices and so must be either 1 or 2 bytes. -- compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.yaml -- gpmc,cs-on-ns: Chip-select assertion time -- gpmc,cs-rd-off-ns: Chip-select de-assertion time for reads -- gpmc,cs-wr-off-ns: Chip-select de-assertion time for writes -- gpmc,oe-on-ns: Output-enable assertion time -- gpmc,oe-off-ns: Output-enable de-assertion time -- gpmc,we-on-ns Write-enable assertion time -- gpmc,we-off-ns: Write-enable de-assertion time -- gpmc,access-ns: Start cycle to first data capture (read access) -- gpmc,rd-cycle-ns: Total read cycle time -- gpmc,wr-cycle-ns: Total write cycle time -- linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.yaml -- reg: Chip-select, base address (relative to chip-select) - and size of NOR flash. Note that base address will be - typically 0 as this is the start of the chip-select. - -Optional properties: -- gpmc,XXX Additional GPMC timings and settings parameters. See - Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt - -Optional properties for partition table parsing: -- #address-cells: should be set to 1 -- #size-cells: should be set to 1 - -Example: - -gpmc: gpmc@6e000000 { - compatible = "ti,omap3430-gpmc", "simple-bus"; - ti,hwmods = "gpmc"; - reg = <0x6e000000 0x1000>; - interrupts = <20>; - gpmc,num-cs = <8>; - gpmc,num-waitpins = <4>; - #address-cells = <2>; - #size-cells = <1>; - - ranges = <0 0 0x10000000 0x08000000>; - - nor@0,0 { - compatible = "cfi-flash"; - linux,mtd-name= "intel,pf48f6000m0y1be"; - #address-cells = <1>; - #size-cells = <1>; - reg = <0 0 0x08000000>; - bank-width = <2>; - - gpmc,mux-add-data; - gpmc,cs-on-ns = <0>; - gpmc,cs-rd-off-ns = <186>; - gpmc,cs-wr-off-ns = <186>; - gpmc,adv-on-ns = <12>; - gpmc,adv-rd-off-ns = <48>; - gpmc,adv-wr-off-ns = <48>; - gpmc,oe-on-ns = <54>; - gpmc,oe-off-ns = <168>; - gpmc,we-on-ns = <54>; - gpmc,we-off-ns = <168>; - gpmc,rd-cycle-ns = <186>; - gpmc,wr-cycle-ns = <186>; - gpmc,access-ns = <114>; - gpmc,page-burst-access-ns = <6>; - gpmc,bus-turnaround-ns = <12>; - gpmc,cycle2cycle-delay-ns = <18>; - gpmc,wr-data-mux-bus-ns = <90>; - gpmc,wr-access-ns = <186>; - gpmc,cycle2cycle-samecsen; - gpmc,cycle2cycle-diffcsen; - - partition@0 { - label = "bootloader-nor"; - reg = <0 0x40000>; - }; - partition@40000 { - label = "params-nor"; - reg = <0x40000 0x40000>; - }; - partition@80000 { - label = "kernel-nor"; - reg = <0x80000 0x200000>; - }; - partition@280000 { - label = "filesystem-nor"; - reg = <0x240000 0x7d80000>; - }; - }; -}; -- 2.7.4