From 86cf2ae492db316e73512a1786d57ece9b3a7624 Mon Sep 17 00:00:00 2001 From: Prafulla Wadaskar Date: Sat, 7 Aug 2010 17:44:25 +0530 Subject: [PATCH] Kirkwood: openrd_base: Added SATA support This patch enables mvsata driver and related filesystem support. The patch is tested for ide reset and ext2ls operation for a disk drive connected on SATA port0. This patch depends upon the patche-series http://lists.denx.de/pipermail/u-boot/2010-August/074908.html Signed-off-by: Prafulla Wadaskar --- include/configs/openrd_base.h | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+) diff --git a/include/configs/openrd_base.h b/include/configs/openrd_base.h index 52fa73d..846dfcd 100644 --- a/include/configs/openrd_base.h +++ b/include/configs/openrd_base.h @@ -103,6 +103,7 @@ #define CONFIG_CMD_NAND #define CONFIG_CMD_PING #define CONFIG_CMD_USB +#define CONFIG_CMD_IDE /* * NAND configuration @@ -205,6 +206,36 @@ #endif /* CONFIG_CMD_USB */ /* + * IDe Support on SATA port0 + */ +#ifdef CONFIG_CMD_IDE +#define __io +#define CONFIG_CMD_EXT2 +#define CONFIG_MVSATA_IDE +#define CONFIG_IDE_PREINIT +#define CONFIG_MVSATA_IDE_USE_PORT1 +/* Needs byte-swapping for ATA data register */ +#define CONFIG_IDE_SWAP_IO +/* Data, registers and alternate blocks are at the same offset */ +#define CONFIG_SYS_ATA_DATA_OFFSET (0x0100) +#define CONFIG_SYS_ATA_REG_OFFSET (0x0100) +#define CONFIG_SYS_ATA_ALT_OFFSET (0x0100) +/* Each 8-bit ATA register is aligned to a 4-bytes address */ +#define CONFIG_SYS_ATA_STRIDE 4 +/* Controller supports 48-bits LBA addressing */ +#define CONFIG_LBA48 +/* CONFIG_CMD_IDE requires some #defines for ATA registers */ +#define CONFIG_SYS_IDE_MAXBUS 2 +#define CONFIG_SYS_IDE_MAXDEVICE 2 +/* ATA registers base is at SATA controller base */ +#define CONFIG_SYS_ATA_BASE_ADDR KW_SATA_BASE +/* ATA bus 0 is Kirkwood port 0 on openrd */ +#define CONFIG_SYS_ATA_IDE0_OFFSET KW_SATA_PORT0_OFFSET +/* ATA bus 1 is Kirkwood port 1 on openrd */ +#define CONFIG_SYS_ATA_IDE1_OFFSET KW_SATA_PORT1_OFFSET +#endif /* CONFIG_CMD_IDE */ + +/* * File system */ #define CONFIG_CMD_FAT -- 2.7.4