From 6273f1810f95f4deeb2f0d6810f301726ad32308 Mon Sep 17 00:00:00 2001 From: Peter Chen Date: Thu, 18 Oct 2012 12:24:43 +0800 Subject: [PATCH] USB: EHCI: add condition for delay during the resume Without this condition, all controllers will do this delay, and increase the resume time. Only enabled and unsuspended port needs this delay, but Some buggy hardware(like Synopsys usb controller) will clear suspend bit once they receive/send resume signal, so it takes resume bit as consideration. Tested it at Freescale i.mx6q Sabrelite board. Signed-off-by: Peter Chen Acked-by: Alan Stern Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/ehci-hub.c | 23 ++++++++++++++++++----- 1 file changed, 18 insertions(+), 5 deletions(-) diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c index 914ce93..a7ec827 100644 --- a/drivers/usb/host/ehci-hub.c +++ b/drivers/usb/host/ehci-hub.c @@ -384,11 +384,24 @@ static int ehci_bus_resume (struct usb_hcd *hcd) ehci_writel(ehci, ehci->command, &ehci->regs->command); ehci->rh_state = EHCI_RH_RUNNING; - /* Some controller/firmware combinations need a delay during which - * they set up the port statuses. See Bugzilla #8190. */ - spin_unlock_irq(&ehci->lock); - msleep(8); - spin_lock_irq(&ehci->lock); + /* + * According to Bugzilla #8190, the port status for some controllers + * will be wrong without a delay. At their wrong status, the port + * is enabled, but not suspended neither resumed. + */ + i = HCS_N_PORTS(ehci->hcs_params); + while (i--) { + temp = ehci_readl(ehci, &ehci->regs->port_status[i]); + if ((temp & PORT_PE) && + !(temp & (PORT_SUSPEND | PORT_RESUME))) { + ehci_dbg(ehci, "Port status(0x%x) is wrong\n", temp); + spin_unlock_irq(&ehci->lock); + msleep(8); + spin_lock_irq(&ehci->lock); + break; + } + } + if (ehci->shutdown) goto shutdown; -- 2.7.4