From 57b2712b2b45a4363e792a66a24121a0a7aedf89 Mon Sep 17 00:00:00 2001 From: Lokesh Vutla Date: Fri, 28 Feb 2020 17:56:20 +0530 Subject: [PATCH] dma: ti: k3-udma: Mark flow id as valid parameter for RX channel config When flow id is not marked as valid, sysfw reads the register value to get the range of flow ids that are supported. Then compares the flow range with the U-Boot's host id. This will definitely fail as board configuration doesn't assign the full range to U-Boot's host id. In order to work around this, mark the flow id as valid and pass range as 0. Signed-off-by: Lokesh Vutla --- drivers/dma/ti/k3-udma.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) diff --git a/drivers/dma/ti/k3-udma.c b/drivers/dma/ti/k3-udma.c index e587f1f..a0e536a 100644 --- a/drivers/dma/ti/k3-udma.c +++ b/drivers/dma/ti/k3-udma.c @@ -938,7 +938,9 @@ static int udma_alloc_rchan_sci_req(struct udma_chan *uc) req.valid_params = TI_SCI_MSG_VALUE_RM_UDMAP_CH_FETCH_SIZE_VALID | TI_SCI_MSG_VALUE_RM_UDMAP_CH_CQ_QNUM_VALID | - TI_SCI_MSG_VALUE_RM_UDMAP_CH_CHAN_TYPE_VALID; + TI_SCI_MSG_VALUE_RM_UDMAP_CH_CHAN_TYPE_VALID | + TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_START_VALID | + TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_CNT_VALID; req.nav_id = tisci_rm->tisci_dev_id; req.index = uc->rchan->id; req.rx_chan_type = mode; @@ -954,9 +956,6 @@ static int udma_alloc_rchan_sci_req(struct udma_chan *uc) if (uc->rflow->id != uc->rchan->id && uc->dir != DMA_MEM_TO_MEM) { req.flowid_start = uc->rflow->id; req.flowid_cnt = 1; - req.valid_params |= - TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_START_VALID | - TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_CNT_VALID; } ret = tisci_rm->tisci_udmap_ops->rx_ch_cfg(tisci_rm->tisci, &req); -- 2.7.4