From 50fa9f0bb8c1eb7d0dbd404766a67c34756d5a80 Mon Sep 17 00:00:00 2001 From: Tomi Valkeinen Date: Wed, 23 Nov 2016 13:24:00 +0200 Subject: [PATCH] drm/omap: fix display SYNC/DE flags At the moment VSYNC/HSYNC/DE high/low flags set by the panel/encoder drivers get lost when the videotimings are translated to DRM's videomode, as DRM's mode does not have corresponding flags. DRM has bus-flags for this purpose, and while it lacks a few flags at the moment, it should be used here. However, until we rewrite omapdrm's device model, using bus-flags is rather difficult. As a short term fix, this patch makes sure that every time the videomode is set in omap_crtc_mode_set_nofb(), the driver asks for the SYNC/DE flags from the panel/encoder drivers, and thus we get the correct flags into use. Signed-off-by: Tomi Valkeinen --- drivers/gpu/drm/omapdrm/omap_connector.c | 8 +++++-- drivers/gpu/drm/omapdrm/omap_crtc.c | 40 +++++++++++++++++++++++++++++--- 2 files changed, 43 insertions(+), 5 deletions(-) diff --git a/drivers/gpu/drm/omapdrm/omap_connector.c b/drivers/gpu/drm/omapdrm/omap_connector.c index 50d2b641..c24b6b7 100644 --- a/drivers/gpu/drm/omapdrm/omap_connector.c +++ b/drivers/gpu/drm/omapdrm/omap_connector.c @@ -146,8 +146,6 @@ static int omap_connector_mode_valid(struct drm_connector *connector, int r, ret = MODE_BAD; drm_display_mode_to_videomode(mode, &vm); - vm.flags |= DISPLAY_FLAGS_DE_HIGH | DISPLAY_FLAGS_PIXDATA_POSEDGE | - DISPLAY_FLAGS_SYNC_NEGEDGE; mode->vrefresh = drm_mode_vrefresh(mode); /* @@ -162,6 +160,12 @@ static int omap_connector_mode_valid(struct drm_connector *connector, dssdrv->get_timings(dssdev, &t); + /* + * Ignore the flags, as we don't get them from + * drm_display_mode_to_videomode. + */ + t.flags = 0; + if (memcmp(&vm, &t, sizeof(vm))) r = -EINVAL; else diff --git a/drivers/gpu/drm/omapdrm/omap_crtc.c b/drivers/gpu/drm/omapdrm/omap_crtc.c index 1db96b0..4f03f74 100644 --- a/drivers/gpu/drm/omapdrm/omap_crtc.c +++ b/drivers/gpu/drm/omapdrm/omap_crtc.c @@ -373,6 +373,11 @@ static void omap_crtc_mode_set_nofb(struct drm_crtc *crtc) { struct omap_crtc *omap_crtc = to_omap_crtc(crtc); struct drm_display_mode *mode = &crtc->state->adjusted_mode; + struct omap_drm_private *priv = crtc->dev->dev_private; + const u32 flags_mask = DISPLAY_FLAGS_DE_HIGH | DISPLAY_FLAGS_DE_LOW | + DISPLAY_FLAGS_PIXDATA_POSEDGE | DISPLAY_FLAGS_PIXDATA_NEGEDGE | + DISPLAY_FLAGS_SYNC_POSEDGE | DISPLAY_FLAGS_SYNC_NEGEDGE; + unsigned int i; DBG("%s: set mode: %d:\"%s\" %d %d %d %d %d %d %d %d %d %d 0x%x 0x%x", omap_crtc->name, mode->base.id, mode->name, @@ -382,9 +387,38 @@ static void omap_crtc_mode_set_nofb(struct drm_crtc *crtc) mode->type, mode->flags); drm_display_mode_to_videomode(mode, &omap_crtc->vm); - omap_crtc->vm.flags |= DISPLAY_FLAGS_DE_HIGH | - DISPLAY_FLAGS_PIXDATA_POSEDGE | - DISPLAY_FLAGS_SYNC_NEGEDGE; + + /* + * HACK: This fixes the vm flags. + * struct drm_display_mode does not contain the VSYNC/HSYNC/DE flags + * and they get lost when converting back and forth between + * struct drm_display_mode and struct videomode. The hack below + * goes and fetches the missing flags from the panel drivers. + * + * Correct solution would be to use DRM's bus-flags, but that's not + * easily possible before the omapdrm's panel/encoder driver model + * has been changed to the DRM model. + */ + + for (i = 0; i < priv->num_encoders; ++i) { + struct drm_encoder *encoder = priv->encoders[i]; + + if (encoder->crtc == crtc) { + struct omap_dss_device *dssdev; + + dssdev = omap_encoder_get_dssdev(encoder); + + if (dssdev) { + struct videomode vm = {0}; + + dssdev->driver->get_timings(dssdev, &vm); + + omap_crtc->vm.flags |= vm.flags & flags_mask; + } + + break; + } + } } static int omap_crtc_atomic_check(struct drm_crtc *crtc, -- 2.7.4