From 4bde4a4c4ff53e67cde4b0fe630d6fc28106bff8 Mon Sep 17 00:00:00 2001 From: David Brownell Date: Thu, 27 Dec 2007 11:19:49 -0800 Subject: [PATCH] USB: ohci-at91 uses generic GPIO calls Update the ohci-at91 bus glue to start understanding about the per-port power switch GPIOs it's given (on the sam9263-ek and potentially other boards). For the moment this just claims them and forces them active (assuming active-low power enables) whenever the HCD is loaded. The assumption is still that board setup configures the GPIOs. Using gpio_request() tracks actual usage and guards against conflict. Signed-off-by: David Brownell Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/ohci-at91.c | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+) diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c index d849c80..126fcbd 100644 --- a/drivers/usb/host/ohci-at91.c +++ b/drivers/usb/host/ohci-at91.c @@ -17,6 +17,8 @@ #include #include +#include + #include #include @@ -271,12 +273,41 @@ static const struct hc_driver ohci_at91_hc_driver = { static int ohci_hcd_at91_drv_probe(struct platform_device *pdev) { + struct at91_usbh_data *pdata = pdev->dev.platform_data; + int i; + + if (pdata) { + /* REVISIT make the driver support per-port power switching, + * and also overcurrent detection. Here we assume the ports + * are always powered while this driver is active, and use + * active-low power switches. + */ + for (i = 0; i < pdata->ports; i++) { + if (pdata->vbus_pin[i] <= 0) + continue; + gpio_request(pdata->vbus_pin[i], "ohci_vbus"); + gpio_direction_output(pdata->vbus_pin[i], 0); + } + } + device_init_wakeup(&pdev->dev, 1); return usb_hcd_at91_probe(&ohci_at91_hc_driver, pdev); } static int ohci_hcd_at91_drv_remove(struct platform_device *pdev) { + struct at91_usbh_data *pdata = pdev->dev.platform_data; + int i; + + if (pdata) { + for (i = 0; i < pdata->ports; i++) { + if (pdata->vbus_pin[i] <= 0) + continue; + gpio_direction_output(pdata->vbus_pin[i], 1); + gpio_free(pdata->vbus_pin[i]); + } + } + device_init_wakeup(&pdev->dev, 0); return usb_hcd_at91_remove(platform_get_drvdata(pdev), pdev); } -- 2.7.4