From 3f6e6986045d47f87bd982910821b7ab9758487e Mon Sep 17 00:00:00 2001 From: Masahiro Yamada Date: Sat, 23 Jun 2018 01:06:34 +0900 Subject: [PATCH] mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz unconditionally Since commit 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()"), denali_dt.c gets the clock rate from the clock driver. The driver expects the frequency of the bus interface clock, whereas the clock driver of SOCFPGA provides the core clock. Thus, the setup_data_interface() hook calculates timing parameters based on a wrong frequency. To make it work without relying on the clock driver, hard-code the clock frequency, 200MHz. This is fine for existing DT of UniPhier, and also fixes the issue of SOCFPGA because both platforms use 200 MHz for the bus interface clock. Fixes: 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()") Cc: linux-stable #4.14+ Reported-by: Philipp Rosenberger Suggested-by: Boris Brezillon Signed-off-by: Masahiro Yamada Tested-by: Richard Weinberger Signed-off-by: Boris Brezillon --- drivers/mtd/nand/raw/denali_dt.c | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-) diff --git a/drivers/mtd/nand/raw/denali_dt.c b/drivers/mtd/nand/raw/denali_dt.c index cfd33e6..5869e90 100644 --- a/drivers/mtd/nand/raw/denali_dt.c +++ b/drivers/mtd/nand/raw/denali_dt.c @@ -123,7 +123,11 @@ static int denali_dt_probe(struct platform_device *pdev) if (ret) return ret; - denali->clk_x_rate = clk_get_rate(dt->clk); + /* + * Hardcode the clock rate for the backward compatibility. + * This works for both SOCFPGA and UniPhier. + */ + denali->clk_x_rate = 200000000; ret = denali_init(denali); if (ret) -- 2.7.4