From 256d0eaac87da1e993190846064f339f4c7a63f5 Mon Sep 17 00:00:00 2001 From: "Stephen M. Cameron" Date: Fri, 14 Sep 2012 16:34:25 -0500 Subject: [PATCH] [SCSI] hpsa: fix handling of protocol error If a command status of CMD_PROTOCOL_ERR is received, this information should be conveyed to the SCSI mid layer, not dropped on the floor. CMD_PROTOCOL_ERR may be received from the Smart Array for any commands destined for an external RAID controller such as a P2000, or commands destined for tape drives or CD/DVD-ROM drives, if for instance a cable is disconnected. This mostly affects multipath configurations, as disconnecting a cable on a non-multipath configuration is not going to do anything good regardless of whether CMD_PROTOCOL_ERR is handled correctly or not. Not handling CMD_PROTOCOL_ERR correctly in a multipath configaration involving external RAID controllers may cause data corruption, so this is quite a serious bug. This bug should not normally cause a problem for direct attached disk storage. Signed-off-by: Stephen M. Cameron Cc: stable@vger.kernel.org Signed-off-by: James Bottomley --- drivers/scsi/hpsa.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c index 796482b..2b4261c 100644 --- a/drivers/scsi/hpsa.c +++ b/drivers/scsi/hpsa.c @@ -1315,8 +1315,9 @@ static void complete_scsi_command(struct CommandList *cp) } break; case CMD_PROTOCOL_ERR: + cmd->result = DID_ERROR << 16; dev_warn(&h->pdev->dev, "cp %p has " - "protocol error \n", cp); + "protocol error\n", cp); break; case CMD_HARDWARE_ERR: cmd->result = DID_ERROR << 16; -- 2.7.4