From: satya priya Date: Mon, 14 Sep 2020 13:58:34 +0000 (+0530) Subject: arm64: dts: qcom: sc7180: Improve the uart3 pin config for sc7180-idp X-Git-Tag: v5.15~2574^2~25^2~38 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=ff11a79878a8b43394b296c06557033efd17b1ee;p=platform%2Fkernel%2Flinux-starfive.git arm64: dts: qcom: sc7180: Improve the uart3 pin config for sc7180-idp Remove output-high from CTS and TX as this is not really required. During bringup to fix transfer failures this was added to match with console uart settings. Probably some boot loader config was missing then. As it is working fine now, remove it. Signed-off-by: satya priya Reviewed-by: Matthias Kaehlcke Reviewed-by: Douglas Anderson Link: https://lore.kernel.org/r/1600091917-7464-2-git-send-email-skakit@codeaurora.org Signed-off-by: Bjorn Andersson --- diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts index d033b3a..cd8e6fa 100644 --- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts +++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts @@ -473,32 +473,30 @@ &qup_uart3_default { pinconf-cts { /* - * Configure a pull-down on 38 (CTS) to match the pull of + * Configure a pull-down on CTS to match the pull of * the Bluetooth module. */ pins = "gpio38"; bias-pull-down; - output-high; }; pinconf-rts { - /* We'll drive 39 (RTS), so no pull */ + /* We'll drive RTS, so no pull */ pins = "gpio39"; drive-strength = <2>; bias-disable; }; pinconf-tx { - /* We'll drive 40 (TX), so no pull */ + /* We'll drive TX, so no pull */ pins = "gpio40"; drive-strength = <2>; bias-disable; - output-high; }; pinconf-rx { /* - * Configure a pull-up on 41 (RX). This is needed to avoid + * Configure a pull-up on RX. This is needed to avoid * garbage data when the TX pin of the Bluetooth module is * in tri-state (module powered off or not driving the * signal yet).