From: Alexey Kardashevskiy Date: Fri, 29 Apr 2016 08:55:20 +0000 (+1000) Subject: powerpc/powernv/npu: Simplify DMA setup X-Git-Tag: v4.14-rc1~3199^2~14 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=f9f834567432e4d21f26debe10e1ca0ab52446e5;p=platform%2Fkernel%2Flinux-rpi.git powerpc/powernv/npu: Simplify DMA setup NPU devices are emulated in firmware and mainly used for NPU NVLink training; one NPU device is per a hardware link. Their DMA/TCE setup must match the GPU which is connected via PCIe and NVLink so any changes to the DMA/TCE setup on the GPU PCIe device need to be propagated to the NVLink device as this is what device drivers expect and it doesn't make much sense to do anything else. This makes NPU DMA setup explicit. pnv_npu_ioda_controller_ops::pnv_npu_dma_set_mask is moved to pci-ioda, made static and prints warning as dma_set_mask() should never be called on this function as in any case it will not configure GPU; so we make this explicit. Instead of using PNV_IODA_PE_PEER and peers[] (which the next patch will remove), we test every PCI device if there are corresponding NVLink devices. If there are any, we propagate bypass mode to just found NPU devices by calling the setup helper directly (which takes @bypass) and avoid guessing (i.e. calculating from DMA mask) whether we need bypass or not on NPU devices. Since DMA setup happens in very rare occasion, this will not slow down booting or VFIO start/stop much. This renames pnv_npu_disable_bypass to pnv_npu_dma_set_32 to make it more clear what the function really does which is programming 32bit table address to the TVT ("disabling bypass" means writing zeroes to the TVT). This removes pnv_npu_dma_set_bypass() from pnv_npu_ioda_fixup() as the DMA configuration on NPU does not matter until dma_set_mask() is called on GPU and that will do the NPU DMA configuration. This removes phb->dma_dev_setup initialization for NPU as pnv_pci_ioda_dma_dev_setup is no-op for it anyway. This stops using npe->tce_bypass_base as it never changes and values other than zero are not supported. Signed-off-by: Alexey Kardashevskiy Reviewed-by: David Gibson Reviewed-by: Alistair Popple Signed-off-by: Michael Ellerman --- diff --git a/arch/powerpc/platforms/powernv/npu-dma.c b/arch/powerpc/platforms/powernv/npu-dma.c index 5bd5fee..bec9267 100644 --- a/arch/powerpc/platforms/powernv/npu-dma.c +++ b/arch/powerpc/platforms/powernv/npu-dma.c @@ -196,10 +196,9 @@ void pnv_npu_init_dma_pe(struct pnv_ioda_pe *npe) } /* - * For the NPU we want to point the TCE table at the same table as the - * real PCI device. + * Enables 32 bit DMA on NPU. */ -static void pnv_npu_disable_bypass(struct pnv_ioda_pe *npe) +static void pnv_npu_dma_set_32(struct pnv_ioda_pe *npe) { struct pnv_phb *phb = npe->phb; struct pci_dev *gpdev; @@ -235,72 +234,62 @@ static void pnv_npu_disable_bypass(struct pnv_ioda_pe *npe) } /* - * Enable/disable bypass mode on the NPU. The NPU only supports one + * Enables bypass mode on the NPU. The NPU only supports one * window per link, so bypass needs to be explicitly enabled or * disabled. Unlike for a PHB3 bypass and non-bypass modes can't be * active at the same time. */ -int pnv_npu_dma_set_bypass(struct pnv_ioda_pe *npe, bool enable) +static int pnv_npu_dma_set_bypass(struct pnv_ioda_pe *npe) { struct pnv_phb *phb = npe->phb; int64_t rc = 0; + phys_addr_t top = memblock_end_of_DRAM(); if (phb->type != PNV_PHB_NPU || !npe->pdev) return -EINVAL; - if (enable) { - /* Enable the bypass window */ - phys_addr_t top = memblock_end_of_DRAM(); - - npe->tce_bypass_base = 0; - top = roundup_pow_of_two(top); - dev_info(&npe->pdev->dev, "Enabling bypass for PE %d\n", - npe->pe_number); - rc = opal_pci_map_pe_dma_window_real(phb->opal_id, - npe->pe_number, npe->pe_number, - npe->tce_bypass_base, top); - } else { - /* - * Disable the bypass window by replacing it with the - * TCE32 window. - */ - pnv_npu_disable_bypass(npe); - } + /* Enable the bypass window */ + + top = roundup_pow_of_two(top); + dev_info(&npe->pdev->dev, "Enabling bypass for PE %d\n", + npe->pe_number); + rc = opal_pci_map_pe_dma_window_real(phb->opal_id, + npe->pe_number, npe->pe_number, + 0 /* bypass base */, top); return rc; } -int pnv_npu_dma_set_mask(struct pci_dev *npdev, u64 dma_mask) +void pnv_npu_try_dma_set_bypass(struct pci_dev *gpdev, bool bypass) { - struct pci_controller *hose = pci_bus_to_host(npdev->bus); - struct pnv_phb *phb = hose->private_data; - struct pci_dn *pdn = pci_get_pdn(npdev); - struct pnv_ioda_pe *npe, *gpe; - struct pci_dev *gpdev; - uint64_t top; - bool bypass = false; + int i; + struct pnv_phb *phb; + struct pci_dn *pdn; + struct pnv_ioda_pe *npe; + struct pci_dev *npdev; - if (WARN_ON(!pdn || pdn->pe_number == IODA_INVALID_PE)) - return -ENXIO; + for (i = 0; ; ++i) { + npdev = pnv_pci_get_npu_dev(gpdev, i); - /* We only do bypass if it's enabled on the linked device */ - npe = &phb->ioda.pe_array[pdn->pe_number]; - gpe = get_gpu_pci_dev_and_pe(npe, &gpdev); - if (!gpe) - return -ENODEV; + if (!npdev) + break; - if (gpe->tce_bypass_enabled) { - top = gpe->tce_bypass_base + memblock_end_of_DRAM() - 1; - bypass = (dma_mask >= top); - } + pdn = pci_get_pdn(npdev); + if (WARN_ON(!pdn || pdn->pe_number == IODA_INVALID_PE)) + return; - if (bypass) - dev_info(&npdev->dev, "Using 64-bit DMA iommu bypass\n"); - else - dev_info(&npdev->dev, "Using 32-bit DMA via iommu\n"); + phb = pci_bus_to_host(npdev->bus)->private_data; - pnv_npu_dma_set_bypass(npe, bypass); - *npdev->dev.dma_mask = dma_mask; + /* We only do bypass if it's enabled on the linked device */ + npe = &phb->ioda.pe_array[pdn->pe_number]; - return 0; + if (bypass) { + dev_info(&npdev->dev, + "Using 64-bit DMA iommu bypass\n"); + pnv_npu_dma_set_bypass(npe); + } else { + dev_info(&npdev->dev, "Using 32-bit DMA via iommu\n"); + pnv_npu_dma_set_32(npe); + } + } } diff --git a/arch/powerpc/platforms/powernv/pci-ioda.c b/arch/powerpc/platforms/powernv/pci-ioda.c index 9b99aa1..c94ee1b 100644 --- a/arch/powerpc/platforms/powernv/pci-ioda.c +++ b/arch/powerpc/platforms/powernv/pci-ioda.c @@ -1669,8 +1669,6 @@ static int pnv_pci_ioda_dma_set_mask(struct pci_dev *pdev, u64 dma_mask) struct pnv_ioda_pe *pe; uint64_t top; bool bypass = false; - struct pci_dev *linked_npu_dev; - int i; if (WARN_ON(!pdn || pdn->pe_number == IODA_INVALID_PE)) return -ENODEV;; @@ -1691,15 +1689,7 @@ static int pnv_pci_ioda_dma_set_mask(struct pci_dev *pdev, u64 dma_mask) *pdev->dev.dma_mask = dma_mask; /* Update peer npu devices */ - if (pe->flags & PNV_IODA_PE_PEER) - for (i = 0; i < PNV_IODA_MAX_PEER_PES; i++) { - if (!pe->peers[i]) - continue; - - linked_npu_dev = pe->peers[i]->pdev; - if (dma_get_mask(&linked_npu_dev->dev) != dma_mask) - dma_set_mask(&linked_npu_dev->dev, dma_mask); - } + pnv_npu_try_dma_set_bypass(pdev, bypass); return 0; } @@ -3194,7 +3184,6 @@ static void pnv_npu_ioda_fixup(void) enable_bypass = dma_get_mask(&pe->pdev->dev) == DMA_BIT_MASK(64); pnv_npu_init_dma_pe(pe); - pnv_npu_dma_set_bypass(pe, enable_bypass); } } } @@ -3340,6 +3329,14 @@ static const struct pci_controller_ops pnv_pci_ioda_controller_ops = { .shutdown = pnv_pci_ioda_shutdown, }; +static int pnv_npu_dma_set_mask(struct pci_dev *npdev, u64 dma_mask) +{ + dev_err_once(&npdev->dev, + "%s operation unsupported for NVLink devices\n", + __func__); + return -EPERM; +} + static const struct pci_controller_ops pnv_npu_ioda_controller_ops = { .dma_dev_setup = pnv_pci_dma_dev_setup, #ifdef CONFIG_PCI_MSI @@ -3516,9 +3513,6 @@ static void __init pnv_pci_init_ioda_phb(struct device_node *np, phb->freeze_pe = pnv_ioda_freeze_pe; phb->unfreeze_pe = pnv_ioda_unfreeze_pe; - /* Setup TCEs */ - phb->dma_dev_setup = pnv_pci_ioda_dma_dev_setup; - /* Setup MSI support */ pnv_pci_init_ioda_msis(phb); @@ -3531,10 +3525,12 @@ static void __init pnv_pci_init_ioda_phb(struct device_node *np, */ ppc_md.pcibios_fixup = pnv_pci_ioda_fixup; - if (phb->type == PNV_PHB_NPU) + if (phb->type == PNV_PHB_NPU) { hose->controller_ops = pnv_npu_ioda_controller_ops; - else + } else { + phb->dma_dev_setup = pnv_pci_ioda_dma_dev_setup; hose->controller_ops = pnv_pci_ioda_controller_ops; + } #ifdef CONFIG_PCI_IOV ppc_md.pcibios_fixup_sriov = pnv_pci_ioda_fixup_iov_resources; diff --git a/arch/powerpc/platforms/powernv/pci.h b/arch/powerpc/platforms/powernv/pci.h index 85436e3..a38349a 100644 --- a/arch/powerpc/platforms/powernv/pci.h +++ b/arch/powerpc/platforms/powernv/pci.h @@ -220,8 +220,7 @@ extern void pnv_teardown_msi_irqs(struct pci_dev *pdev); /* Nvlink functions */ extern void pnv_npu_init_dma_pe(struct pnv_ioda_pe *npe); extern void pnv_npu_setup_dma_pe(struct pnv_ioda_pe *npe); -extern int pnv_npu_dma_set_bypass(struct pnv_ioda_pe *npe, bool enabled); -extern int pnv_npu_dma_set_mask(struct pci_dev *npdev, u64 dma_mask); +extern void pnv_npu_try_dma_set_bypass(struct pci_dev *gpdev, bool bypass); extern void pnv_pci_ioda2_tce_invalidate_entire(struct pnv_phb *phb, bool rm); #endif /* __POWERNV_PCI_H */