From: Dan Murphy Date: Fri, 23 Aug 2019 17:50:56 +0000 (-0500) Subject: dt-bindings: can: tcan4x5x: Update binding to use interrupt property X-Git-Tag: v5.4-rc1~131^2~81^2~13 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=e3b329221567ac86bd667bfb644ac04c867b71cb;p=platform%2Fkernel%2Flinux-rpi.git dt-bindings: can: tcan4x5x: Update binding to use interrupt property Remove the data-ready-gpio property in favor of the DT standard interrupt-parent and interrupts. Signed-off-by: Dan Murphy Signed-off-by: Marc Kleine-Budde --- diff --git a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt index c388f7d..27e1b4c 100644 --- a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt +++ b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt @@ -10,8 +10,10 @@ Required properties: - #size-cells: 0 - spi-max-frequency: Maximum frequency of the SPI bus the chip can operate at should be less than or equal to 18 MHz. - - data-ready-gpios: Interrupt GPIO for data and error reporting. - device-wake-gpios: Wake up GPIO to wake up the TCAN device. + - interrupt-parent: the phandle to the interrupt controller which provides + the interrupt. + - interrupts: interrupt specification for data-ready. See Documentation/devicetree/bindings/net/can/m_can.txt for additional required property details. @@ -30,7 +32,8 @@ tcan4x5x: tcan4x5x@0 { #size-cells = <1>; spi-max-frequency = <10000000>; bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>; - data-ready-gpios = <&gpio1 14 GPIO_ACTIVE_LOW>; + interrupt-parent = <&gpio1>; + interrupts = <14 GPIO_ACTIVE_LOW>; device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>; device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>; reset-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;