From: Lee Jones Date: Wed, 6 Nov 2013 10:05:42 +0000 (+0000) Subject: ARM: ux500: Remove legacy ATAG SSP support X-Git-Tag: v3.14-rc1~36^2~6^2~41 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=d4033047bb07efd6377c45b7b92c308e3b52a6a0;p=profile%2Fivi%2Fkernel-x86-ivi.git ARM: ux500: Remove legacy ATAG SSP support This hasn't been used since we converted the platform to DT only. Signed-off-by: Lee Jones Signed-off-by: Linus Walleij --- diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c index 514d40b..d552163 100644 --- a/arch/arm/mach-ux500/board-mop500.c +++ b/arch/arm/mach-ux500/board-mop500.c @@ -46,33 +46,3 @@ struct ab8500_platform_data ab8500_platdata = { .irq_base = MOP500_AB8500_IRQ_BASE, .regulator = &ab8500_regulator_plat_data, }; - -#ifdef CONFIG_STE_DMA40 -static struct stedma40_chan_cfg ssp0_dma_cfg_rx = { - .mode = STEDMA40_MODE_LOGICAL, - .dir = DMA_DEV_TO_MEM, - .dev_type = DB8500_DMA_DEV8_SSP0, -}; - -static struct stedma40_chan_cfg ssp0_dma_cfg_tx = { - .mode = STEDMA40_MODE_LOGICAL, - .dir = DMA_MEM_TO_DEV, - .dev_type = DB8500_DMA_DEV8_SSP0, -}; -#endif - -struct pl022_ssp_controller ssp0_plat = { - .bus_id = 0, -#ifdef CONFIG_STE_DMA40 - .enable_dma = 1, - .dma_filter = stedma40_filter, - .dma_rx_param = &ssp0_dma_cfg_rx, - .dma_tx_param = &ssp0_dma_cfg_tx, -#else - .enable_dma = 0, -#endif - /* on this platform, gpio 31,142,144,214 & - * 224 are connected as chip selects - */ - .num_chipselect = 5, -}; diff --git a/arch/arm/mach-ux500/board-mop500.h b/arch/arm/mach-ux500/board-mop500.h index 511d6fe..d48e866 100644 --- a/arch/arm/mach-ux500/board-mop500.h +++ b/arch/arm/mach-ux500/board-mop500.h @@ -87,7 +87,6 @@ extern struct msp_i2s_platform_data msp0_platform_data; extern struct msp_i2s_platform_data msp1_platform_data; extern struct msp_i2s_platform_data msp2_platform_data; extern struct msp_i2s_platform_data msp3_platform_data; -extern struct pl022_ssp_controller ssp0_plat; void __init mop500_pinmaps_init(void); void __init snowball_pinmaps_init(void);