From: Tali Perry Date: Sun, 20 Sep 2020 20:48:09 +0000 (+0300) Subject: i2c: npcm7xx: Clear LAST bit after a failed transaction. X-Git-Tag: v5.15~2805^2 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=8947efc077168c53b84d039881a7c967086a248a;p=platform%2Fkernel%2Flinux-starfive.git i2c: npcm7xx: Clear LAST bit after a failed transaction. Due to a HW issue, in some scenarios the LAST bit might remain set. This will cause an unexpected NACK after reading 16 bytes on the next read. Example: if user tries to read from a missing device, get a NACK, then if the next command is a long read ( > 16 bytes), the master will stop reading after 16 bytes. To solve this, if a command fails, check if LAST bit is still set. If it does, reset the module. Fixes: 56a1485b102e (i2c: npcm7xx: Add Nuvoton NPCM I2C controller driver) Signed-off-by: Tali Perry Signed-off-by: Wolfram Sang --- diff --git a/drivers/i2c/busses/i2c-npcm7xx.c b/drivers/i2c/busses/i2c-npcm7xx.c index dfcf04e..2ad1663 100644 --- a/drivers/i2c/busses/i2c-npcm7xx.c +++ b/drivers/i2c/busses/i2c-npcm7xx.c @@ -2163,6 +2163,15 @@ static int npcm_i2c_master_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, if (bus->cmd_err == -EAGAIN) ret = i2c_recover_bus(adap); + /* + * After any type of error, check if LAST bit is still set, + * due to a HW issue. + * It cannot be cleared without resetting the module. + */ + if (bus->cmd_err && + (NPCM_I2CRXF_CTL_LAST_PEC & ioread8(bus->reg + NPCM_I2CRXF_CTL))) + npcm_i2c_reset(bus); + #if IS_ENABLED(CONFIG_I2C_SLAVE) /* reenable slave if it was enabled */ if (bus->slave)