From: H Hartley Sweeten Date: Tue, 22 Mar 2016 18:10:26 +0000 (-0700) Subject: staging: comedi: ni_660x: fix block comment issues X-Git-Tag: v5.15~13567^2~616 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=6d40805b0b4e4392e68fea0028edcafa5fcdc04a;p=platform%2Fkernel%2Flinux-starfive.git staging: comedi: ni_660x: fix block comment issues Fix the checkpatch.pl issues about: WARNING: Block comments use * on subsequent lines WARNING: Block comments use a trailing */ on a separate line Signed-off-by: H Hartley Sweeten Reviewed-by: Ian Abbott Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/staging/comedi/drivers/ni_660x.c b/drivers/staging/comedi/drivers/ni_660x.c index 232c8976..0183497 100644 --- a/drivers/staging/comedi/drivers/ni_660x.c +++ b/drivers/staging/comedi/drivers/ni_660x.c @@ -48,8 +48,7 @@ enum ni_660x_constants { }; #define NUM_PFI_CHANNELS 40 -/* really there are only up to 3 dma channels, but the register layout allows -for 4 */ +/* there are only up to 3 dma channels, but the register layout allows for 4 */ #define MAX_DMA_CHANNEL 4 /* See Register-Level Programmer Manual page 3.1 */ @@ -985,8 +984,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev, s->range_table = &range_digital; s->insn_bits = ni_660x_dio_insn_bits; s->insn_config = ni_660x_dio_insn_config; - /* we use the ioconfig registers to control dio direction, so zero - output enables in stc dio control reg */ + + /* + * We use the ioconfig registers to control dio direction, so zero + * output enables in stc dio control reg. + */ ni_660x_write(dev, 0, 0, NI660X_STC_DIO_CONTROL); devpriv->counter_dev = ni_gpct_device_construct(dev, @@ -1040,8 +1042,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev, NI660X_IO_CFG_OUT_SEL_COUNTER); ni_660x_select_pfi_output(dev, i, NI660X_IO_CFG_OUT_SEL_HIGH_Z); } - /* to be safe, set counterswap bits on tio chips after all the counter - outputs have been set to high impedance mode */ + + /* + * To be safe, set counterswap bits on tio chips after all the counter + * outputs have been set to high impedance mode. + */ for (i = 0; i < board->n_chips; ++i) set_tio_counterswap(dev, i);