From: Linus Walleij Date: Wed, 4 Dec 2019 23:32:30 +0000 (+0100) Subject: staging: fbtft: Do not hardcode SPI CS polarity inversion X-Git-Tag: v5.10.7~3638^2~10 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=453a4b6d8e1bdff2b8e1f56f4b8a8ef6d36b0e77;p=platform%2Fkernel%2Flinux-rpi.git staging: fbtft: Do not hardcode SPI CS polarity inversion The current use of the mode flag SPI_CS_HIGH is fragile: it overwrites anything already assigned by the SPI core. Assign ^= SPI_CS_HIGH since we might be active high already, and that is usually the case with GPIOs used for chip select, even if they are in practice active low. Add a comment clarifying why ^= SPI_CS_HIGH is the right choice here. Reported-by: Mark Brown Signed-off-by: Linus Walleij Link: https://lore.kernel.org/r/20191204233230.22309-1-linus.walleij@linaro.org Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/staging/fbtft/fb_uc1611.c b/drivers/staging/fbtft/fb_uc1611.c index e763205..f61e373 100644 --- a/drivers/staging/fbtft/fb_uc1611.c +++ b/drivers/staging/fbtft/fb_uc1611.c @@ -63,11 +63,17 @@ static int init_display(struct fbtft_par *par) { int ret; - /* Set CS active high */ - par->spi->mode |= SPI_CS_HIGH; + /* + * Set CS active inverse polarity: just setting SPI_CS_HIGH does not + * work with GPIO based chip selects that are logically active high + * but inverted inside the GPIO library, so enforce inverted + * semantics. + */ + par->spi->mode ^= SPI_CS_HIGH; ret = spi_setup(par->spi); if (ret) { - dev_err(par->info->device, "Could not set SPI_CS_HIGH\n"); + dev_err(par->info->device, + "Could not set inverse CS polarity\n"); return ret; } diff --git a/drivers/staging/fbtft/fb_watterott.c b/drivers/staging/fbtft/fb_watterott.c index 27cc8ea..76b25df 100644 --- a/drivers/staging/fbtft/fb_watterott.c +++ b/drivers/staging/fbtft/fb_watterott.c @@ -150,10 +150,17 @@ static int init_display(struct fbtft_par *par) /* enable SPI interface by having CS and MOSI low during reset */ save_mode = par->spi->mode; - par->spi->mode |= SPI_CS_HIGH; - ret = spi_setup(par->spi); /* set CS inactive low */ + /* + * Set CS active inverse polarity: just setting SPI_CS_HIGH does not + * work with GPIO based chip selects that are logically active high + * but inverted inside the GPIO library, so enforce inverted + * semantics. + */ + par->spi->mode ^= SPI_CS_HIGH; + ret = spi_setup(par->spi); if (ret) { - dev_err(par->info->device, "Could not set SPI_CS_HIGH\n"); + dev_err(par->info->device, + "Could not set inverse CS polarity\n"); return ret; } write_reg(par, 0x00); /* make sure mode is set */