From: Emil Tantilov Date: Wed, 17 May 2017 22:17:46 +0000 (-0700) Subject: ixgbe: add write flush when configuring CS4223/7 X-Git-Tag: v4.13-rc1~157^2~331^2~3 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=410a494902777c11f95031d9ed757d7f8f09c5c6;p=platform%2Fkernel%2Flinux-exynos.git ixgbe: add write flush when configuring CS4223/7 Make sure the writes are processed immediately. Without the flush it is possible for operations on one port to spill over the other as the resource is shared. Signed-off-by: Emil Tantilov Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c index 32b35ef..80824fe 100644 --- a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c +++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c @@ -1824,12 +1824,28 @@ ixgbe_setup_mac_link_sfp_x550a(struct ixgbe_hw *hw, ixgbe_link_speed speed, /* Configure CS4227/CS4223 LINE side to proper mode. */ reg_slice = IXGBE_CS4227_LINE_SPARE24_LSB + slice_offset; + + ret_val = hw->phy.ops.read_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, ®_phy_ext); + if (ret_val) + return ret_val; + + reg_phy_ext &= ~((IXGBE_CS4227_EDC_MODE_CX1 << 1) | + (IXGBE_CS4227_EDC_MODE_SR << 1)); + if (setup_linear) reg_phy_ext = (IXGBE_CS4227_EDC_MODE_CX1 << 1) | 1; else reg_phy_ext = (IXGBE_CS4227_EDC_MODE_SR << 1) | 1; - return hw->phy.ops.write_reg(hw, reg_slice, IXGBE_MDIO_ZERO_DEV_TYPE, - reg_phy_ext); + + ret_val = hw->phy.ops.write_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, reg_phy_ext); + if (ret_val) + return ret_val; + + /* Flush previous write with a read */ + return hw->phy.ops.read_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, ®_phy_ext); } /**