From: Christian Riesch Date: Fri, 14 Jun 2013 12:22:36 +0000 (+0200) Subject: da850evm: Use clrbits function with correct endianess X-Git-Tag: v2013.10-rc1~22^2~76 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=3864cb2133b8d4a45dbad603f7b0b9f051d617ff;p=platform%2Fkernel%2Fu-boot.git da850evm: Use clrbits function with correct endianess The current code uses clrbits_be32 which is incorrect since we are on a little endian machine here. This patch fixes this issue and also removes some unnecessary code: Reading the current GPIO bank state is not required if we are using the SET and CLEAR GPIO registers for setting/clearing bits. Signed-off-by: Christian Riesch Cc: Nagabhushana Netagunte Cc: Rajashekhara, Sudhakar --- diff --git a/board/davinci/da8xxevm/da850evm.c b/board/davinci/da8xxevm/da850evm.c index 01745b2..85b4830 100644 --- a/board/davinci/da8xxevm/da850evm.c +++ b/board/davinci/da8xxevm/da850evm.c @@ -323,10 +323,6 @@ int board_early_init_f(void) int board_init(void) { -#if defined(CONFIG_USE_NOR) || defined(CONFIG_DAVINCI_MMC) - u32 val; -#endif - #ifndef CONFIG_USE_IRQ irq_init(); #endif @@ -366,12 +362,10 @@ int board_init(void) #ifdef CONFIG_USE_NOR /* Set the GPIO direction as output */ - clrbits_be32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11)); + clrbits_le32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11)); /* Set the output as low */ - val = readl(GPIO_BANK0_REG_SET_ADDR); - val |= (0x01 << 11); - writel(val, GPIO_BANK0_REG_CLR_ADDR); + writel(0x01 << 11, GPIO_BANK0_REG_CLR_ADDR); #endif #ifdef CONFIG_DAVINCI_MMC @@ -379,9 +373,7 @@ int board_init(void) clrbits_le32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11)); /* Set the output as high */ - val = readl(GPIO_BANK0_REG_SET_ADDR); - val |= (0x01 << 11); - writel(val, GPIO_BANK0_REG_SET_ADDR); + writel(0x01 << 11, GPIO_BANK0_REG_SET_ADDR); #endif #ifdef CONFIG_DRIVER_TI_EMAC