From: Robert Hancock Date: Tue, 18 Jan 2022 21:52:43 +0000 (-0600) Subject: net: phy: broadcom: hook up soft_reset for BCM54616S X-Git-Tag: accepted/tizen/unified/20230118.172025~2746 X-Git-Url: http://review.tizen.org/git/?a=commitdiff_plain;h=36c7e4f4a3ec57ed663011e7b3acd77f3becfa9d;p=platform%2Fkernel%2Flinux-rpi.git net: phy: broadcom: hook up soft_reset for BCM54616S [ Upstream commit d15c7e875d44367005370e6a82e8f3a382a04f9b ] A problem was encountered with the Bel-Fuse 1GBT-SFP05 SFP module (which is a 1 Gbps copper module operating in SGMII mode with an internal BCM54616S PHY device) using the Xilinx AXI Ethernet MAC core, where the module would work properly on the initial insertion or boot of the device, but after the device was rebooted, the link would either only come up at 100 Mbps speeds or go up and down erratically. I found no meaningful changes in the PHY configuration registers between the working and non-working boots, but the status registers seemed to have a lot of error indications set on the SERDES side of the device on the non-working boot. I suspect the problem is that whatever happens on the SGMII link when the device is rebooted and the FPGA logic gets reloaded ends up putting the module's onboard PHY into a bad state. Since commit 6e2d85ec0559 ("net: phy: Stop with excessive soft reset") the genphy_soft_reset call is not made automatically by the PHY core unless the callback is explicitly specified in the driver structure. For most of these Broadcom devices, there is probably a hardware reset that gets asserted to reset the PHY during boot, however for SFP modules (where the BCM54616S is commonly found) no such reset line exists, so if the board keeps the SFP cage powered up across a reboot, it will end up with no reset occurring during reboots. Hook up the genphy_soft_reset callback for BCM54616S to ensure that a PHY reset is performed before the device is initialized. This appears to fix the issue with erratic operation after a reboot with this SFP module. Fixes: 6e2d85ec0559 ("net: phy: Stop with excessive soft reset") Signed-off-by: Robert Hancock Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller Signed-off-by: Sasha Levin --- diff --git a/drivers/net/phy/broadcom.c b/drivers/net/phy/broadcom.c index 83aea5c..db26ff8 100644 --- a/drivers/net/phy/broadcom.c +++ b/drivers/net/phy/broadcom.c @@ -768,6 +768,7 @@ static struct phy_driver broadcom_drivers[] = { .phy_id_mask = 0xfffffff0, .name = "Broadcom BCM54616S", /* PHY_GBIT_FEATURES */ + .soft_reset = genphy_soft_reset, .config_init = bcm54xx_config_init, .config_aneg = bcm54616s_config_aneg, .config_intr = bcm_phy_config_intr,