thermal: sti: Remove obsolete platforms from the DT doc.

STiH415/6 SoC's are being removed from the kernel. This
patch removes the compatibles from the dt doc and also
updates the example to a supported platform.

Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Cc: <rui.zhang@intel.com>
Cc: <edubezval@gmail.com>
Cc: <robh+dt@kernel.org>
Acked-by: Rob Herring <robh@kernel.org>

diff --git a/Documentation/devicetree/bindings/thermal/st-thermal.txt b/Documentation/devicetree/bindings/thermal/st-thermal.txt
index 3b9251b..a2f9391 100644 (file)
--- a/Documentation/devicetree/bindings/thermal/st-thermal.txt
+++ b/Documentation/devicetree/bindings/thermal/st-thermal.txt
@@ -3,17 +3,8 @@ Binding for Thermal Sensor driver for STMicroelectronics STi series of SoCs.
 Required parameters:
 -------------------
 
-compatible :   st,<SoC>-<module>-thermal; should be one of:
-                 "st,stih415-sas-thermal",
-                 "st,stih415-mpe-thermal",
-                 "st,stih416-sas-thermal"
-                 "st,stih416-mpe-thermal"
-                 "st,stid127-thermal" or
-                 "st,stih407-thermal"
-               according to the SoC type (stih415, stih416, stid127, stih407)
-               and module type (sas or mpe). On stid127 & stih407 there is only
-               one die/module, so there is no module type in the compatible
-               string.
+compatible :   Should be "st,stih407-thermal"
+
 clock-names :  Should be "thermal".
                  See: Documentation/devicetree/bindings/resource-names.txt
 clocks :       Phandle of the clock used by the thermal sensor.
@@ -25,18 +16,17 @@ Optional parameters:
 reg :          For non-sysconf based sensors, this should be the physical base
                address and length of the sensor's registers.
 interrupts :   Standard way to define interrupt number.
-               Interrupt is mandatory to be defined when compatible is
-               "stih416-mpe-thermal".
                  NB: For thermal sensor's for which no interrupt has been
                  defined, a polling delay of 1000ms will be used to read the
                  temperature from device.
 
 Example:
 
-       temp1@fdfe8000 {
-               compatible      = "st,stih416-mpe-thermal";
-               reg             = <0xfdfe8000 0x10>;
-               clock-names     = "thermal";
-               clocks          = <&clk_m_mpethsens>;
-               interrupts      = <GIC_SPI 23 IRQ_TYPE_NONE>;
+       temp0@91a0000 {
+               compatible = "st,stih407-thermal";
+               reg = <0x91a0000 0x28>;
+               clock-names = "thermal";
+               clocks = <&CLK_SYSIN>;
+               interrupts = <GIC_SPI 205 IRQ_TYPE_EDGE_RISING>;
+               st,passive_cooling_temp = <110>;
        };