bnx2x: Change duplex setting in EEE function

This is not a real problem, since the EEE is supported for devices where the
actual_phy_selection is zero, such that the req_duplex of params will match
the one of the phy struct.

Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index ebab35d..3e7d824 100644 (file)
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
@@ -10119,7 +10119,7 @@ static int bnx2x_848x3_config_init(struct bnx2x_phy *phy,
                        return rc;
                }
 
-               if ((params->req_duplex[actual_phy_selection] == DUPLEX_FULL) &&
+               if ((phy->req_duplex == DUPLEX_FULL) &&
                    (params->eee_mode & EEE_MODE_ADV_LPI) &&
                    (bnx2x_eee_calc_timer(params) ||
                     !(params->eee_mode & EEE_MODE_ENABLE_LPI)))
@@ -13451,7 +13451,7 @@ static void bnx2x_check_kr2_wa(struct link_params *params,
        if (!(vars->link_attr_sync & LINK_ATTR_SYNC_KR2_ENABLE)) {
                if (!not_kr2_device) {
                        DP(NETIF_MSG_LINK, "BP=0x%x, NP=0x%x\n", base_page,
-                          next_page);
+                                      next_page);
                        bnx2x_kr2_recovery(params, vars, phy);
                }
                return;