sky2: fix PM related regressions

Fix the problems reported for 2.6.27-rc1 caused by over aggressive
power management. Turning clock off on PCI Express is problematic for WOL,
and when doing multi-booting.

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 5257cf4..7d29edc 100644 (file)
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -275,86 +275,6 @@ static void sky2_power_aux(struct sky2_hw *hw)
                             PC_VAUX_ON | PC_VCC_OFF));
 }
 
-static void sky2_power_state(struct sky2_hw *hw, pci_power_t state)
-{
-       u16 power_control = sky2_pci_read16(hw, hw->pm_cap + PCI_PM_CTRL);
-       int pex = pci_find_capability(hw->pdev, PCI_CAP_ID_EXP);
-       u32 reg;
-
-       sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON);
-
-       switch (state) {
-       case PCI_D0:
-               break;
-
-       case PCI_D1:
-               power_control |= 1;
-               break;
-
-       case PCI_D2:
-               power_control |= 2;
-               break;
-
-       case PCI_D3hot:
-       case PCI_D3cold:
-               power_control |= 3;
-               if (hw->flags & SKY2_HW_ADV_POWER_CTL) {
-                       /* additional power saving measurements */
-                       reg = sky2_pci_read32(hw, PCI_DEV_REG4);
-
-                       /* set gating core clock for LTSSM in L1 state */
-                       reg |= P_PEX_LTSSM_STAT(P_PEX_LTSSM_L1_STAT) |
-                               /* auto clock gated scheme controlled by CLKREQ */
-                               P_ASPM_A1_MODE_SELECT |
-                               /* enable Gate Root Core Clock */
-                               P_CLK_GATE_ROOT_COR_ENA;
-
-                       if (pex && (hw->flags & SKY2_HW_CLK_POWER)) {
-                               /* enable Clock Power Management (CLKREQ) */
-                               u16 ctrl = sky2_pci_read16(hw, pex + PCI_EXP_DEVCTL);
-
-                               ctrl |= PCI_EXP_DEVCTL_AUX_PME;
-                               sky2_pci_write16(hw, pex + PCI_EXP_DEVCTL, ctrl);
-                       } else
-                               /* force CLKREQ Enable in Our4 (A1b only) */
-                               reg |= P_ASPM_FORCE_CLKREQ_ENA;
-
-                       /* set Mask Register for Release/Gate Clock */
-                       sky2_pci_write32(hw, PCI_DEV_REG5,
-                                        P_REL_PCIE_EXIT_L1_ST | P_GAT_PCIE_ENTER_L1_ST |
-                                        P_REL_PCIE_RX_EX_IDLE | P_GAT_PCIE_RX_EL_IDLE |
-                                        P_REL_GPHY_LINK_UP | P_GAT_GPHY_LINK_DOWN);
-               } else
-                       sky2_write8(hw, B28_Y2_ASF_STAT_CMD, Y2_ASF_CLK_HALT);
-
-               /* put CPU into reset state */
-               sky2_write8(hw,  B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_RESET);
-               if (hw->chip_id == CHIP_ID_YUKON_SUPR && hw->chip_rev == CHIP_REV_YU_SU_A0)
-                       /* put CPU into halt state */
-                       sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_HALTED);
-
-               if (pex && !(hw->flags & SKY2_HW_RAM_BUFFER)) {
-                       reg = sky2_pci_read32(hw, PCI_DEV_REG1);
-                       /* force to PCIe L1 */
-                       reg |= PCI_FORCE_PEX_L1;
-                       sky2_pci_write32(hw, PCI_DEV_REG1, reg);
-               }
-               break;
-
-       default:
-               dev_warn(&hw->pdev->dev, PFX "Invalid power state (%d) ",
-                      state);
-               return;
-       }
-
-       power_control |= PCI_PM_CTRL_PME_ENABLE;
-       /* Finally, set the new power state. */
-       sky2_pci_write32(hw, hw->pm_cap + PCI_PM_CTRL, power_control);
-
-       sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
-       sky2_pci_read32(hw, B0_CTST);
-}
-
 static void sky2_gmac_reset(struct sky2_hw *hw, unsigned port)
 {
        u16 reg;
@@ -709,6 +629,11 @@ static void sky2_phy_power_up(struct sky2_hw *hw, unsigned port)
        sky2_pci_write32(hw, PCI_DEV_REG1, reg1);
        sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
        sky2_pci_read32(hw, PCI_DEV_REG1);
+
+       if (hw->chip_id == CHIP_ID_YUKON_FE)
+               gm_phy_write(hw, port, PHY_MARV_CTRL, PHY_CT_ANE);
+       else if (hw->flags & SKY2_HW_ADV_POWER_CTL)
+               sky2_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_CLR);
 }
 
 static void sky2_phy_power_down(struct sky2_hw *hw, unsigned port)
@@ -2855,10 +2780,6 @@ static int __devinit sky2_init(struct sky2_hw *hw)
                hw->flags = SKY2_HW_GIGABIT
                        | SKY2_HW_NEWER_PHY
                        | SKY2_HW_ADV_POWER_CTL;
-
-               /* check for Rev. A1 dev 4200 */
-               if (sky2_read16(hw, Q_ADDR(Q_XA1, Q_WM)) == 0)
-                       hw->flags |= SKY2_HW_CLK_POWER;
                break;
 
        case CHIP_ID_YUKON_EX:
@@ -2914,12 +2835,6 @@ static int __devinit sky2_init(struct sky2_hw *hw)
        if (hw->pmd_type == 'L' || hw->pmd_type == 'S' || hw->pmd_type == 'P')
                hw->flags |= SKY2_HW_FIBRE_PHY;
 
-       hw->pm_cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PM);
-       if (hw->pm_cap == 0) {
-               dev_err(&hw->pdev->dev, "cannot find PowerManagement capability\n");
-               return -EIO;
-       }
-
        hw->ports = 1;
        t8 = sky2_read8(hw, B2_Y2_HW_RES);
        if ((t8 & CFG_DUAL_MAC_MSK) == CFG_DUAL_MAC_MSK) {
@@ -4512,7 +4427,7 @@ static int sky2_suspend(struct pci_dev *pdev, pm_message_t state)
 
        pci_save_state(pdev);
        pci_enable_wake(pdev, pci_choose_state(pdev, state), wol);
-       sky2_power_state(hw, pci_choose_state(pdev, state));
+       pci_set_power_state(pdev, pci_choose_state(pdev, state));
 
        return 0;
 }
@@ -4525,7 +4440,9 @@ static int sky2_resume(struct pci_dev *pdev)
        if (!hw)
                return 0;
 
-       sky2_power_state(hw, PCI_D0);
+       err = pci_set_power_state(pdev, PCI_D0);
+       if (err)
+               goto out;
 
        err = pci_restore_state(pdev);
        if (err)
@@ -4595,7 +4512,7 @@ static void sky2_shutdown(struct pci_dev *pdev)
        pci_enable_wake(pdev, PCI_D3cold, wol);
 
        pci_disable_device(pdev);
-       sky2_power_state(hw, PCI_D3hot);
+       pci_set_power_state(pdev, PCI_D3hot);
 }
 
 static struct pci_driver sky2_driver = {

diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h
index 4d9c4a1..92fb24b 100644 (file)
--- a/drivers/net/sky2.h
+++ b/drivers/net/sky2.h
@@ -2072,9 +2072,7 @@ struct sky2_hw {
 #define SKY2_HW_NEW_LE         0x00000020      /* new LSOv2 format */
 #define SKY2_HW_AUTO_TX_SUM    0x00000040      /* new IP decode for Tx */
 #define SKY2_HW_ADV_POWER_CTL  0x00000080      /* additional PHY power regs */
-#define SKY2_HW_CLK_POWER      0x00000100      /* clock power management */
 
-       int                  pm_cap;
        u8                   chip_id;
        u8                   chip_rev;
        u8                   pmd_type;