* value of 1 volt.
*
* The only defined flag value is %RF_EXTERNAL (%0x100), indicating that the
- * the range needs to be multiplied by an external reference.
+ * range needs to be multiplied by an external reference.
*/
struct comedi_krange {
int min;
* major reasons exist why this caused major confusion for users:
* 1) The register values are _NOT_ in user documentation, but rather in
* arcane locations, such as a few register programming manuals that are
- * increasingly hard to find and the NI MHDDK (comments in in example code).
+ * increasingly hard to find and the NI MHDDK (comments in example code).
* There is no one place to find the various valid values of the registers.
* 2) The register values are _NOT_ completely consistent. There is no way to
* gain any sense of intuition of which values, or even enums one should use
* @range: Array of &struct comedi_krange, one for each range.
*
* Each element of @range[] describes the minimum and maximum physical range
- * range and the type of units. Typically, the type of unit is %UNIT_volt
+ * and the type of units. Typically, the type of unit is %UNIT_volt
* (i.e. volts) and the minimum and maximum are in millionths of a volt.
* There may also be a flag that indicates the minimum and maximum are merely
* scale factors for an unknown, external reference.
{
struct apci1564_private *devpriv = dev->private;
- /* just write the last last to the reload register */
+ /* just write the last to the reload register */
if (insn->n) {
unsigned int val = data[insn->n - 1];
unsigned int chan = CR_CHAN(insn->chanspec);
unsigned long iobase = devpriv->counters + APCI1564_COUNTER(chan);
- /* just write the last last to the reload register */
+ /* just write the last to the reload register */
if (insn->n) {
unsigned int val = data[insn->n - 1];
* subdev_8255_regbase - get offset of 8255 registers or call-back context
* @s: comedi subdevice
*
- * Returns the 'regbase' parameter that was previously passed to to
+ * Returns the 'regbase' parameter that was previously passed to
* subdev_8255_init() or subdev_8255_mm_init() to set up the subdevice.
* Only valid if the subdevice was set up successfully.
*/
* This should be done, but we don't yet know the actual
* register values. These should be tested and then documented
* in the ni_route_values/ni_*.csv files, with indication of
- * who/when/which/how these these were tested.
+ * who/when/which/how these were tested.
* When at least a e/m/660x series have been tested, this code
* should be uncommented:
*
*
* In the 48-channel version:
*
- * On subdev 0, the first 24 channels channels are edge-detect channels.
+ * On subdev 0, the first 24 channels are edge-detect channels.
*
* In the 96-channel board you have the following channels that can do edge
* detection:
/*
* Reset any pending interrupts (my card has a tendency to require
- * require multiple reads on the status register to achieve this).
+ * multiple reads on the status register to achieve this).
*/
while (--loops) {
status = inb(dev->iobase + DAQP_STATUS_REG);