DID_TARGET_FAILURE is internal to the SCSI layer. Drivers must not use it
because:
1. It's not propagated upwards, so SG IO/passthrough users will not see an
error and think a command was successful.
2. There is no handling for it in scsi_decide_disposition() so it results
in entering SCSI error handling.
It looks like the driver wanted a hard failure so this swaps it with
DID_BAD_TARGET which gives us that behavior. The error looks like it's for
a case where the target did not support a TMF we wanted to use (maybe not a
bad target but disappointing so close enough).
Link: https://lore.kernel.org/r/20220812010027.8251-4-michael.christie@oracle.com
Signed-off-by: Mike Christie <michael.christie@oracle.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
set_host_byte(cmnd, DID_OK);
break;
case RC_TMF_NOT_SUPPORTED:
- set_host_byte(cmnd, DID_TARGET_FAILURE);
+ set_host_byte(cmnd, DID_BAD_TARGET);
break;
default:
uas_log_cmd_state(cmnd, "response iu", response_code);