iio: adc: qcom-spmi-adc5: Use driver datasheet_name instead of DT label

iio_chan_spec::datasheet_name expects a channel/pin name on the hardware
part, i.e. from its datasheet, instead of a friendly name from DT which
typically describes the use of said channel.  GPIO channels are commonly
specialized in QCOM board DTS based on what a - typically thermistor -
is connected to.

Also rename adc5_channel_prop::datasheet_name to channel_name to that
effect.

Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20230502-iio-adc-propagate-fw-node-label-v3-2-6be5db6e6b5a@somainline.org
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

diff --git a/drivers/iio/adc/qcom-spmi-adc5.c b/drivers/iio/adc/qcom-spmi-adc5.c
index c2d5e06..6e4e5cb 100644 (file)
--- a/drivers/iio/adc/qcom-spmi-adc5.c
+++ b/drivers/iio/adc/qcom-spmi-adc5.c
@@ -114,7 +114,7 @@ enum adc5_cal_val {
  *     that is an average of multiple measurements.
  * @scale_fn_type: Represents the scaling function to convert voltage
  *     physical units desired by the client for the channel.
- * @datasheet_name: Channel name used in device tree.
+ * @channel_name: Channel name used in device tree.
  */
 struct adc5_channel_prop {
        unsigned int            channel;
@@ -126,7 +126,7 @@ struct adc5_channel_prop {
        unsigned int            hw_settle_time;
        unsigned int            avg_samples;
        enum vadc_scale_fn_type scale_fn_type;
-       const char              *datasheet_name;
+       const char              *channel_name;
 };
 
 /**
@@ -671,7 +671,7 @@ static int adc5_get_fw_channel_data(struct adc5_chip *adc,
        if (ret)
                channel_name = name;
 
-       prop->datasheet_name = channel_name;
+       prop->channel_name = channel_name;
 
        ret = fwnode_property_read_u32(fwnode, "qcom,decimation", &value);
        if (!ret) {
@@ -861,8 +861,8 @@ static int adc5_get_fw_data(struct adc5_chip *adc)
                adc_chan = &adc->data->adc_chans[prop.channel];
 
                iio_chan->channel = prop.channel;
-               iio_chan->datasheet_name = prop.datasheet_name;
-               iio_chan->extend_name = prop.datasheet_name;
+               iio_chan->datasheet_name = adc_chan->datasheet_name;
+               iio_chan->extend_name = prop.channel_name;
                iio_chan->info_mask_separate = adc_chan->info_mask;
                iio_chan->type = adc_chan->type;
                iio_chan->address = index;