arm: dts: meson: Fix IRQ trigger type for macirq

A long running stress test on a custom board shipping an AXG SoCs and a
Realtek RTL8211F PHY revealed that after a few hours the connection
speed would drop drastically, from ~1000Mbps to ~3Mbps. At the same time
the 'macirq' (eth0) IRQ would stop being triggered at all and as
consequence the GMAC IRQs never ACKed.

After a painful investigation the problem seemed to be due to a wrong
defined IRQ type for the GMAC IRQ that should be LEVEL_HIGH instead of
EDGE_RISING.

The change in the macirq IRQ type also solved another long standing
issue affecting this SoC/PHY where EEE was causing the network
connection to die after stressing it with iperf3 (even though much
sooner). It's now possible to remove the 'eee-broken-1000t' quirk as
well.

Fixes: 9c15795a4f96 ("ARM: dts: meson8b-odroidc1: ethernet support")
Signed-off-by: Carlo Caione <ccaione@baylibre.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>

diff --git a/arch/arm/boot/dts/meson.dtsi b/arch/arm/boot/dts/meson.dtsi
index e4645f6..2ab7486 100644 (file)
--- a/arch/arm/boot/dts/meson.dtsi
+++ b/arch/arm/boot/dts/meson.dtsi
@@ -274,7 +274,7 @@
                        compatible = "amlogic,meson6-dwmac", "snps,dwmac";
                        reg = <0xc9410000 0x10000
                               0xc1108108 0x4>;
-                       interrupts = <GIC_SPI 8 IRQ_TYPE_EDGE_RISING>;
+                       interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
                        interrupt-names = "macirq";
                        status = "disabled";
                };

diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index 58669ab..a951a66 100644 (file)
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -221,7 +221,6 @@
                /* Realtek RTL8211F (0x001cc916) */
                eth_phy: ethernet-phy@0 {
                        reg = <0>;
-                       eee-broken-1000t;
                        interrupt-parent = <&gpio_intc>;
                        /* GPIOH_3 */
                        interrupts = <17 IRQ_TYPE_LEVEL_LOW>;