ARM: ux500: Remove legacy ATAG SSP support
authorLee Jones <lee.jones@linaro.org>
Wed, 6 Nov 2013 10:05:42 +0000 (10:05 +0000)
committerLinus Walleij <linus.walleij@linaro.org>
Tue, 26 Nov 2013 20:01:54 +0000 (21:01 +0100)
This hasn't been used since we converted the platform to DT only.

Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
arch/arm/mach-ux500/board-mop500.c
arch/arm/mach-ux500/board-mop500.h

index 514d40b..d552163 100644 (file)
@@ -46,33 +46,3 @@ struct ab8500_platform_data ab8500_platdata = {
        .irq_base       = MOP500_AB8500_IRQ_BASE,
        .regulator      = &ab8500_regulator_plat_data,
 };
-
-#ifdef CONFIG_STE_DMA40
-static struct stedma40_chan_cfg ssp0_dma_cfg_rx = {
-       .mode = STEDMA40_MODE_LOGICAL,
-       .dir = DMA_DEV_TO_MEM,
-       .dev_type = DB8500_DMA_DEV8_SSP0,
-};
-
-static struct stedma40_chan_cfg ssp0_dma_cfg_tx = {
-       .mode = STEDMA40_MODE_LOGICAL,
-       .dir = DMA_MEM_TO_DEV,
-       .dev_type = DB8500_DMA_DEV8_SSP0,
-};
-#endif
-
-struct pl022_ssp_controller ssp0_plat = {
-       .bus_id = 0,
-#ifdef CONFIG_STE_DMA40
-       .enable_dma = 1,
-       .dma_filter = stedma40_filter,
-       .dma_rx_param = &ssp0_dma_cfg_rx,
-       .dma_tx_param = &ssp0_dma_cfg_tx,
-#else
-       .enable_dma = 0,
-#endif
-       /* on this platform, gpio 31,142,144,214 &
-        * 224 are connected as chip selects
-        */
-       .num_chipselect = 5,
-};
index 511d6fe..d48e866 100644 (file)
@@ -87,7 +87,6 @@ extern struct msp_i2s_platform_data msp0_platform_data;
 extern struct msp_i2s_platform_data msp1_platform_data;
 extern struct msp_i2s_platform_data msp2_platform_data;
 extern struct msp_i2s_platform_data msp3_platform_data;
-extern struct pl022_ssp_controller ssp0_plat;
 
 void __init mop500_pinmaps_init(void);
 void __init snowball_pinmaps_init(void);