i2c: designware: Add debug print for bus speed

Trivial added debug print for dev->clk_freq doesn't necessarily tell the
actual bus speed or mode the controller is operating. For instance it
may indicate 1 MHz Fast Mode Plus or 3.4 MHz High Speed but driver ends up
using 400 kHz Fast Mode due missing timing parameters or missing support
from HW.

Add a debug print that prints the bus speed based on the validated speed
that gets programmed into a HW.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

diff --git a/drivers/i2c/busses/i2c-designware-master.c b/drivers/i2c/busses/i2c-designware-master.c
index 2b671ca..fc7c255 100644 (file)
--- a/drivers/i2c/busses/i2c-designware-master.c
+++ b/drivers/i2c/busses/i2c-designware-master.c
@@ -48,7 +48,7 @@ static void i2c_dw_configure_fifo_master(struct dw_i2c_dev *dev)
 static int i2c_dw_set_timings_master(struct dw_i2c_dev *dev)
 {
        u32 ic_clk = i2c_dw_clk_rate(dev);
-       const char *fp_str = "";
+       const char *mode_str, *fp_str = "";
        u32 comp_param1;
        u32 sda_falling_time, scl_falling_time;
        int ret;
@@ -132,7 +132,24 @@ static int i2c_dw_set_timings_master(struct dw_i2c_dev *dev)
                }
        }
 
-       return i2c_dw_set_sda_hold(dev);
+       ret = i2c_dw_set_sda_hold(dev);
+       if (ret)
+               goto out;
+
+       switch (dev->master_cfg & DW_IC_CON_SPEED_MASK) {
+       case DW_IC_CON_SPEED_STD:
+               mode_str = "Standard Mode";
+               break;
+       case DW_IC_CON_SPEED_HIGH:
+               mode_str = "High Speed Mode";
+               break;
+       default:
+               mode_str = "Fast Mode";
+       }
+       dev_dbg(dev->dev, "Bus speed: %s%s\n", mode_str, fp_str);
+
+out:
+       return ret;
 }
 
 /**