Pull ARM SoC 64-bit changes and additions from Olof Johansson:
"The 64-bit set of updates this release cycle adds support for three
new platforms:
- Samsunc Exynos 7
- Freescale LS2085a
- Mediatek MT8173
For all these, the changes mostly consititude additions of DT
contents, but also some Kconfig entries to allow dependency/selection
of drivers per-platform, etc"
* tag '64bit-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
arm64: Kconfig: clean up two no-op Kconfig options from CONFIG_ARCH_TEGRA*
arm64: Fix sort of platform Kconfig entries
arm64: Add support for FSL's LS2085A SoC in Kconfig and defconfig
arm64: Add DTS support for FSL's LS2085A SoC
arm64: mediatek: Add MT8173 SoC Kconfig and defconfig
arm64: dts: Add mediatek MT8173 SoC and evaluation board dts and Makefile
Document: DT: Add bindings for mediatek MT8173 SoC Platform
arm64: Add Tegra132 support
arm64: Enable ARMv8 based exynos7 SoC support
arm64: dts: Add nodes for mmc, i2c, rtc, watchdog, adc on exynos7
arm64: dts: Add PMU DT node for exynos7 SoC
arm64: dts: Add initial pinctrl support to exynos7
arm64: dts: Add initial device tree support for exynos7
Required properties:
- compatible: should be one of:
+ "mediatek,mt8173-sysirq"
"mediatek,mt8135-sysirq"
"mediatek,mt8127-sysirq"
+ "mediatek,mt6592-sysirq"
"mediatek,mt6589-sysirq"
"mediatek,mt6582-sysirq"
"mediatek,mt6577-sysirq"
Required properties:
- compatible should contain:
+ * "mediatek,mt8135-uart" for MT8135 compatible UARTS
+ * "mediatek,mt8127-uart" for MT8127 compatible UARTS
+ * "mediatek,mt8173-uart" for MT8173 compatible UARTS
* "mediatek,mt6589-uart" for MT6589 compatible UARTS
* "mediatek,mt6582-uart" for MT6582 compatible UARTS
- * "mediatek,mt6577-uart" for all compatible UARTS (MT6589, MT6582, MT6577)
+ * "mediatek,mt6577-uart" for all compatible UARTS (MT8173, MT6589, MT6582,
+ MT6577)
- reg: The base address of the UART register bank.
dts-dirs += apm
dts-dirs += arm
dts-dirs += cavium
+ dts-dirs += exynos
+ dts-dirs += freescale
+ dts-dirs += mediatek
-always := $(dtb-y)
subdir-y := $(dts-dirs)
-clean-files := *.dtb