The usual behavior of mask registers is writing a '1' bit to
disable (mask) an interrupt; similarly, writing a '1' bit to
an unmask register enables (unmasks) an interrupt.
Due to a longstanding issue in regmap-irq, mask and unmask
registers were inverted when both kinds of registers were
present on the same chip, ie. regmap-irq actually wrote '1's
to the mask register to enable an IRQ and '1's to the unmask
register to disable an IRQ.
This was fixed by commit
e8ffb12e7f06 ("regmap-irq: Fix
inverted handling of unmask registers") but the fix is opt-in
via mask_unmask_non_inverted = true because it requires manual
changes for each affected driver. The new behavior will become
the default once all drivers have been updated.
The STPMIC1 has a normal mask register with separate set and
clear registers. The driver intends to use the set & clear
registers with regmap-irq and has compensated for regmap-irq's
inverted behavior, and should currently be working properly.
Thus, swap mask_base and unmask_base, and opt in to the new
non-inverted behavior.
Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0@gmail.com>
Signed-off-by: Lee Jones <lee@kernel.org>
Link: https://lore.kernel.org/r/20221112151835.39059-16-aidanmacdonald.0x0@gmail.com
static const struct regmap_irq_chip stpmic1_regmap_irq_chip = {
.name = "pmic_irq",
.status_base = INT_PENDING_R1,
- .mask_base = INT_CLEAR_MASK_R1,
- .unmask_base = INT_SET_MASK_R1,
+ .mask_base = INT_SET_MASK_R1,
+ .unmask_base = INT_CLEAR_MASK_R1,
+ .mask_unmask_non_inverted = true,
.ack_base = INT_CLEAR_R1,
.num_regs = STPMIC1_PMIC_NUM_IRQ_REGS,
.irqs = stpmic1_irqs,