&pioA {
pinctrl_key_gpio_default: key_gpio_default {
- pinmux= <PIN_PA22__GPIO>,
+ pinmux = <PIN_PA22__GPIO>,
<PIN_PA24__GPIO>,
<PIN_PA26__GPIO>,
<PIN_PA29__GPIO>,
sw1 {
label = "SW1";
gpios = <&pioD 18 GPIO_ACTIVE_LOW>;
- linux,code=<KEY_PROG1>;
+ linux,code = <KEY_PROG1>;
wakeup-source;
};
};
compatible = "atmel,sama5d27-som1", "atmel,sama5d27", "atmel,sama5d2", "atmel,sama5";
aliases {
- i2c0 = &i2c0;
+ i2c0 = &i2c0;
};
clocks {
serial0 = &uart1; /* DBGU */
serial1 = &uart4; /* mikro BUS 1 */
serial2 = &uart2; /* mikro BUS 2 */
- i2c1 = &i2c1;
- i2c2 = &i2c3;
+ i2c1 = &i2c1;
+ i2c2 = &i2c3;
};
chosen {
serial1 = &uart6; /* BT */
serial2 = &uart5; /* mikro BUS 2 */
serial3 = &uart3; /* mikro BUS 1 */
- i2c1 = &i2c1;
+ i2c1 = &i2c1;
};
chosen {
serial1 = &uart1; /* mikro BUS 3 */
serial3 = &uart3; /* mikro BUS 2 */
serial5 = &uart7; /* flx2 */
- i2c0 = &i2c0;
- i2c1 = &i2c1;
+ i2c0 = &i2c0;
+ i2c1 = &i2c1;
};
chosen {
aliases {
serial0 = &uart0; /* DBGU */
- i2c0 = &i2c0; /* mikroBUS 1 */
- i2c1 = &i2c1; /* XPRO EXT1 */
- i2c2 = &i2c2;
+ i2c0 = &i2c0; /* mikroBUS 1 */
+ i2c1 = &i2c1; /* XPRO EXT1 */
+ i2c2 = &i2c2;
};
chosen {
regulator-state-mem {
regulator-on-in-suspend;
- regulator-suspend-min-microvolt=<1400000>;
- regulator-suspend-max-microvolt=<1400000>;
+ regulator-suspend-min-microvolt = <1400000>;
+ regulator-suspend-max-microvolt = <1400000>;
regulator-changeable-in-suspend;
- regulator-mode=<ACT8945A_REGULATOR_MODE_LOWPOWER>;
+ regulator-mode = <ACT8945A_REGULATOR_MODE_LOWPOWER>;
};
};
interrupts = <18 IRQ_TYPE_LEVEL_HIGH 4>;
clocks = <&pmc PMC_TYPE_PERIPHERAL 18>;
#pwm-cells = <3>;
- status="disabled";
+ status = "disabled";
};
hlcdc: hlcdc@f8038000 {