dt-bindings: mtd: ingenic: Use standard ecc-engine property

The 'ingenic,bch-controller' property is now deprecated and the
'ecc-engine' property should be used instead.

Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
index 5a45cc5..c022593 100644 (file)
--- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
@@ -14,7 +14,7 @@ Required NAND controller device properties:
   an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).
 
 Optional NAND controller device properties:
-- ingenic,bch-controller: To make use of the hardware ECC controller, this
+- ecc-engine: To make use of the hardware ECC controller, this
   property must contain a phandle for the ECC controller node. The required
   properties for this node are described below. If this is not specified,
   software ECC will be used instead.
@@ -48,7 +48,7 @@ nemc: nemc@13410000 {
                #address-cells = <1>;
                #size-cells = <0>;
 
-               ingenic,bch-controller = <&bch>;
+               ecc-engine = <&bch>;
 
                nand@1 {
                        reg = <1>;